Page 1 of 2 12 LastLast
Results 1 to 10 of 20

Thread: Stalls at random

  1. #1
    Senior Member Shawns's Avatar
    Join Date
    Jul 2013
    Posts
    904
    09 replaced the IAC and TPS, with one off of spare throttle body assay. Runs fine then will stall. No check engine light. Did do the TPS reset after I replaced it. I replaced both when the bike refused to idle, had codes for IAC and TPS. Cleaned both and no change so I replaced.

  2. #2
    Senior Member
    Join Date
    Jun 2013
    Posts
    904
    Im.sure you have checked most things. Just throwing it out there, ecm connections good? Grounding issues? Short to ground? Battery? I don't think I will be much help. Kinda looking forward to hearing what it is as I know you are too. Very strange

  3. #3
    Senior Member
    Join Date
    Jul 2010
    Posts
    1,613
    loose positive battery cable?

  4. #4
    Senior Member rchuff's Avatar
    Join Date
    Apr 2012
    Location
    Willow Grove, Pa
    Posts
    2,018
    you should take a look to see where your AFV % is at with either( ecmspy or tunerpro ). it should be around 100 + - a little.

  5. #5
    Senior Member Shawns's Avatar
    Join Date
    Jul 2013
    Posts
    904
    afv% front and rear ar 100. I just sent in for the full activation. I really don't know what i'm looking at. Everything changes values in the live data log. fuel pressure does decrease during run time. it starts at around 80 psi and goes down to about 60 psi at idle.

  6. #6
    Senior Member Shawns's Avatar
    Join Date
    Jul 2013
    Posts
    904
    Still doesn't idle well. I am thinking of adjusting the idle at the throttle body to bring it up a hair. Waiting for Ecmspy to get the donation noted so I can get more into the ECM. I have the race ECM and I know your not supposed to mess with it, but no codes and I am at a loss here.

  7. #7
    Senior Member
    Join Date
    Apr 2012
    Location
    Milwaukee, WI
    Posts
    631
    so does it fire up with out hesitation? if it does how long does it run before it stalls? Do you blip the throttle or leave it alone? If you blip it does it keep it running or still die?

  8. #8
    Senior Member Shawns's Avatar
    Join Date
    Jul 2013
    Posts
    904
    Doesn't fire up cold without rolling the throttle a few times. It sometimes runs for a few seconds and stalls sometimes a few min. When I ride, sometimes at a stop it will idle sometimes it stalls. No rhyme or reason, not that I have found. Voltage is good, has fuel, has spark, air fuel values seem good. Hence the confusion of why she doesn't idle.

  9. #9
    Senior Member Shawns's Avatar
    Join Date
    Jul 2013
    Posts
    904
    Ok, was playing with the idle, runs for about 30 seconds and would slow down the idle and stall. Got it to idle longer and blip the the throttle and it would stall.

  10. #10
    Junior Member
    Join Date
    Sep 2014
    Posts
    8
    Sounds like a fueling issue



Page 1 of 2 12 LastLast

Similar Threads

  1. 03' XB9 stalls after filling
    By SaltPro in forum Buell Firebolt XB12, XB9
    Replies: 2
    Last Post: 04-16-2014, 12:26 AM
  2. 03 Blast stalls when given gas
    By dcv2683 in forum Troubleshooting
    Replies: 4
    Last Post: 11-06-2013, 04:11 PM
  3. Bike Stalls
    By greencupbay in forum Buell Firebolt XB12, XB9
    Replies: 5
    Last Post: 11-25-2012, 08:26 PM
  4. low idle / stalls
    By Expotential in forum Troubleshooting
    Replies: 4
    Last Post: 07-30-2012, 02:21 PM
  5. XB12SCg Stalls when gas low
    By sayahiei in forum Buell Lightning XB12S, XB12Ss, CityX, XB12Scg
    Replies: 4
    Last Post: 09-06-2011, 08:26 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •