I had been reading that the 30f and r was a good starting point. I have used these pressures for a few years now and have no issues.
Here's a video of an afternoon session. Camera bike is an...
Type: Posts; User: mpaternoster
I had been reading that the 30f and r was a good starting point. I have used these pressures for a few years now and have no issues.
Here's a video of an afternoon session. Camera bike is an...
Thanks for the tips guys.
I would say its a bout 1.5" left to the casting.
The headshake wasn't too bad, I admit once I realized how quickly the bike turned in, I started turning in as fast as...
Hi Guys,
Went to the track at New York Safety Track with my City X yesterday with my cousin and her husband. We had a little buell crew. I have had the bike for a year and this was the first time...
Just an update, as cooter has suggested I have wiggled the starter button slightly it starts every time, zero delay. Thanks all for the suggestions.
Ah my mistake, I meant to add this info.
2005 Xb9sx
12,000 miles
Purchased this past june.
Mods: Buell Race exhaust, KN filter, Lower bars, I think some sort of vent bypass. I flashed the race...
Hi again guys.
I have searched here for this an only found one post that sort of resembles my recent issue with no solution.
Basically, when starting the bike, I turn the key, the gauges...
Just an update.
Since reseating the ECM and tightening down on all the grounds and battery terminals, and performing a properly warmed up TPS reset, I have put 200 issue free miles on the bike. ...
Haha, the airbox base has been off for 2 days now. I've been checking for and chafed wires and tightened the big ground wire . Hopefully when I get home today it will either throw the same code and...
TPS screws are good, I was about to check the manual for how to test the TPS. I took the battery out, finally managed to unplug the ECM that didnt want to unplug, and reseated. The TPS is now...
The procedure above is exact how I did it and it was idling great. As soon as I clicked into gear, CEL came on and now the live data from the bueltooth shows TPD stuck on 12.5 and voltage 0.0
OK,
I reset the TPS suggested by a fiend that has a few of these.
I followed the instruction in the video. While warm, I adjusted the idle to 1050ish, TPS is at 5.1. It was idling fine, no...
I hope so, I got this to possibly replace my bandit and be more reliable than my MZ Skorpion.
Still hoping is just bad gas still in the tank from the previous owner, but with running a full tank...
I have not checked any connections yet. Fuel pump behaves normally as far as I can tell.
It cycles on when I turn the key, shuts off after a few seconds. Then it runs after bike starts. Bike...
Bike is a 2005. Previous owner says he never had a CEL, which I find hard to believe. I will do some research on the chafed wires topic. Thanks for your help on this. All fuses look good, I...
Rode home today from work, all was normal. Topped off the tank and rode a few more miles, all good as well. Being home, I plugged in m buelltooth and saw the codes above. I am running the stock...
Hello all,
I have searched for this and it seems over filling the gas tank can cause some running issues.
Twice, soon after getting gas the bike has started stumbling and cutting in and...
Thank you!
Hello,
I recently purchased a 2005 XB9sx and I can't tell what kind of exhaust is on here. I don't think it is the stock one but I'm not too sure. Any help is appreciated.
7886