Search:

Type: Posts; User: shabazz18

Page 1 of 2 1 2

Search: Search took 0.05 seconds.

  1. Replies
    7
    Views
    1,612

    After cleaning everything and running it a...

    After cleaning everything and running it a little, it looks like its coming either from the stator wire grommet or crank sensor. Stator cover was changed recently before I got it, but guess it didnt...
  2. Replies
    7
    Views
    1,612

    Thats an XB though. Does the rear wheel have to...

    Thats an XB though. Does the rear wheel have to be elevated to release belt tension? I don't have a lift or any specialty stuff. Was hoping this could be done with rubber on the ground.
  3. Replies
    7
    Views
    1,612

    Transmission output shaft seal leak

    Now that its running, I have a pretty bad oil leak, I'm pretty sure its the output shaft seal. Any tips on changing this?
  4. Changed the ECM. I have Spark!!! Flashed the...

    Changed the ECM. I have Spark!!! Flashed the factory tune. Now just gotta put it back together and actually ride it for the first time. Thanks for your input.
  5. What would you need for the one you have?

    What would you need for the one you have?
  6. Edit: Duplicate

    Edit: Duplicate
  7. also, I'm in Arlington TX

    also, I'm in Arlington TX
  8. Checked ground to battery and subframe, is there...

    Checked ground to battery and subframe, is there another location I should check? Everything else on your list checks good. It has compression as well, but my gauge is trash so I dont have an...
  9. So, running or not, the known good coil will not...

    So, running or not, the known good coil will not fire, nor is any signal being pushed telling it to, even when sent manually. This is why I suspect the ECM is bad.
  10. No, the coil never fires, even when telling it to...

    No, the coil never fires, even when telling it to fire with ecm droid. Is that not the crank sensor pictured? I thought the speed sensor was on the other side.

    Coil is 3 wire, and I've tested...
  11. Ok, so yes, coils were verified working by...

    Ok, so yes, coils were verified working by installing on the front cylinder. The original rear is now on the front and vice versa. Plugs are new. No codes other than IAC while running. Coil wiring...
  12. Do I look for voltage or ground on the signal...

    Do I look for voltage or ground on the signal wire?
  13. No spark on real cylinder. Coils/wiring check good. What next?

    After sorting through a bunch of other stuff I found my problem. No fire on the rear cylinder. Wiring and coils appear to be good. I've checked multiple coils and they work on the front but not the...
  14. OK. So I tried two different coils on the rear...

    OK. So I tried two different coils on the rear and checked wiring to the ecm. No change. Put the original rear coil on the front and it runs the same, so the coils are good, just no spark on the rear...
  15. So I just pulled the rear coil connector, and no...

    So I just pulled the rear coil connector, and no change in idle or how it runs in general. Think I found my problem. Tested coil with one of the old plugs and no spark at idle with it grounded on the...
  16. all the hose does is filter the incoming air from...

    all the hose does is filter the incoming air from what I understand.
  17. changed plugs and no change really. back to the...

    changed plugs and no change really. back to the drawing board. Where are the ground straps located?
  18. Cleared codes and only thing that came back was...

    Cleared codes and only thing that came back was IAC. Pulled the plugs and they look pretty bad. The threads are also covered in grease of some sort. Anti seize maybe? Kinda looks like it makes for a...
  19. Just ordered a BT reader. So guess I'll wait till...

    Just ordered a BT reader. So guess I'll wait till it shows up and go from there.
  20. Is there a way to clear the codes other than 50...

    Is there a way to clear the codes other than 50 restarts? I'm actually considering taking it up to HD and paying them to diagnose it. Whats that run? $100 bucks or so?
  21. No idea. Has lots of new gaskets though. Head and...

    No idea. Has lots of new gaskets though. Head and stator cover gaskets are bright green still. The guy I got it from only had it about a month. So I really have no idea on the history other than...
  22. New to me '08. Lots of codes and no power. Possible Fuel Pump. Please help.

    Been away from Buells for a while since I sold my '05 Firebolt. I just picked up an '08 1125R with 35k on the clock. Don't know much about the history.

    The bike starts and idles. Sometimes a...
  23. Replies
    34
    Views
    62,116

    I too am have bike for sale. Same only make with...

    I too am have bike for sale. Same only make with gold. I sell you for 5000 us dollars only include ship.
  24. just ecmspy with your stock ecm and a cable...

    just ecmspy with your stock ecm and a cable (available on ebay)
  25. Replies
    4
    Views
    1,096

    take the lights off and put bolts in the holes....

    take the lights off and put bolts in the holes. Front sigs aren't much good for anything anyway.
Results 1 to 25 of 35
Page 1 of 2 1 2