Search:

Type: Posts; User: lifeisafractal

Page 1 of 8 1 2 3 4

Search: Search took 0.17 seconds.

  1. I'm not shocked I'm running lean for the stock...

    I'm not shocked I'm running lean for the stock maps considering the much more open gb exhaust and k&n. That's being said, is that much change in the EGO correction expected over a short time? It...
  2. The AFV was at 114%. So when it enters closed...

    The AFV was at 114%. So when it enters closed loop the EGO correction erratically goes from about 107% to 118%. Like signing over that range in the course of a second or two. Is that normal or kinda...
  3. I'll check the EGO correction when I get home....

    I'll check the EGO correction when I get home. Thanks for the tips of what to look at.
  4. I'll have to check what my AFV is, but I think it...

    I'll have to check what my AFV is, but I think it was around 120%.
  5. When I turned off the O2 sensor and disabled...

    When I turned off the O2 sensor and disabled closed loop things seemed to run better.

    What is the EGO value? Is that the voltage reading in ECM spy? If that's what it is, before going into closed...
  6. So I've been having problems with rough...

    So I've been having problems with rough running/rough idle. I get a slightly unsteady idle, frequently it will miss. It's less so when you get on the gas, but it still doesn't seem quite right. I...
  7. Cool, thanks for the answers! It's deeper than...

    Cool, thanks for the answers! It's deeper than that without a doubt. So now that I know I'm an idiot for not being more careful when taking out the throttle body, what are my options? I assume the...
  8. So I recently took my throttle body out to swap...

    So I recently took my throttle body out to swap the shaft out with one of the custom made ones as the 2007's are know to have a breakage issue. I guess on the way out I scratched the mating surface...
  9. Replies
    5
    Views
    2,265

    Do you have any advice or info on the install...

    Do you have any advice or info on the install beyond what Tootal posted over on badweather? And again, thanks for the input!
  10. Replies
    8
    Views
    1,926

    I have the Corbin gunfigher on my 2007 XB12S. ...

    I have the Corbin gunfigher on my 2007 XB12S. Dunno if that helps, but thought I'd give you any info I could. Its a damn comfy seat I might add too, and you can still move on it to throw the bike...
  11. Replies
    5
    Views
    2,265

    Thanks for the info. I had come across that...

    Thanks for the info. I had come across that thread before and its good to hear your vote of confidence.
  12. One of four things: 1-Bad stator (alternator...

    One of four things:

    1-Bad stator (alternator as you call it)
    Dissconnect the Stator plug and check for proper resistatce across the phases (for '07 and older it is three phase, '08 and new 1...
  13. Replies
    5
    Views
    2,265

    So I was doing some poking around and came across...

    So I was doing some poking around and came across some info that made is sound like the 06 and 07 throttle body shafts had a nasty habbit of breaking. I have an 07, so I'm a little concered. My...
  14. Replies
    14
    Views
    2,073

    I agree, 4.5 hours seems high. I had to do my...

    I agree, 4.5 hours seems high. I had to do my front this past weekend and it took me about 4 hours. So I'd say they are charging you on the high end, but its not crazy. Also, an engine rotate is...
  15. Replies
    49
    Views
    16,175

    Just did a tire change this weekend with a large...

    Just did a tire change this weekend with a large C-clamp to break the bead on the rear tire, worked okay. Be sure to protect the rim from the clamp, but it did work. Takes a little time and effort,...
  16. Replies
    349
    Views
    13,261

    lifeisafractal #1

    lifeisafractal #1
  17. Replies
    36
    Views
    3,413

    liked

    liked
  18. Replies
    4
    Views
    1,093

    You should be thankful that you tracked down an...

    You should be thankful that you tracked down an electrical problem that quick. I've spent days before finding a wire where the insulation melted through due to bad routing near the engine :p
  19. Replies
    4
    Views
    810

    +1 for titties!

    +1 for titties!
  20. Replies
    12
    Views
    1,413

    I'm up in the Boston area and wouldn't mind...

    I'm up in the Boston area and wouldn't mind branching out.
  21. Replies
    4
    Views
    2,350

    http://mods.buellxb.com/index.php?option=com_jdown...

    http://mods.buellxb.com/index.php?option=com_jdownloads&Itemid=54&view=viewcategory&catid=51

    Not sure what you're looking for regaurding the information you need. Here is a download of the shop...
  22. Replies
    45
    Views
    13,867

    Hey Tork, thanks for the thoughts. I've written...

    Hey Tork, thanks for the thoughts. I've written my code to work with a different communications option without major changes. I haven't look too much into USB communication on android before, but a...
  23. Replies
    45
    Views
    13,867

    buellblood, you will still need to get a...

    buellblood, you will still need to get a bluetooth adapter for the bike if you want to use an android app. Also, just in general, if you are a bit of an electronics nerd you can build a serial...
  24. Replies
    11
    Views
    1,970

    I'm gonna go with Xylophone Bike, I like that...

    I'm gonna go with Xylophone Bike, I like that .
  25. Replies
    11
    Views
    1,970

    I just realized I have no idea what the XB in my...

    I just realized I have no idea what the XB in my bike stands for. Anyone know?
Results 1 to 25 of 181
Page 1 of 8 1 2 3 4