Here is the valve chamber condition before seafoam
16500 miles
Here is the valve chamber condition before seafoam
Do you think the dirt in the valve chamber can cause O2 sensor error, and the error gone because of seafoam cleaned the chambers and the valves?
I also did not mention that when I recharged KN air filter it looked like I put too much oil on the pleated material, so the oil even leaked down the air filter. I gave it leak down as much as possible for few hours and then installed it. Is it possible that too much oil on air filter changed airflow capacity and did not let necessary amount of air go in the intake manifold so it affected the engine RPM and O2 sensor?
Last edited by TPEHAK; 11-10-2016 at 08:38 PM.
Alright. Just got new HD Sportster VR and attached it to the motorcycle, now it works with no issues. As I expected that was bad VR.
I've got the Blue Tooth Dongle. I ride second week with no errors. Will this dongle say me what was the last error?
What is the PIN number for the bluetooth dongle? I connected the dongle to the slot and and turned engine switch and ignition switch ON, the dongle lighted up. When I'm trying to connect my phone to bluetooth dongle it's asking PIN number.
Alright, the PIN number is BUELL.
No current errors. Here are the stored errors the ECMDroid shows:
13 | Rear O2 always lean
16 | Battery voltage too low
33 | Fuel pump short to ground
34 | IAC position too low
What does it mean?
I cleared the errors. Will see what will happen.
Last edited by TPEHAK; 11-23-2016 at 04:21 AM.