Nitto12Ss,
What is the round canister on the left side behind the oil cooler???
O3Firebolt9R,
Sorry I missed that last bit. Yes it is my DIY helmet lock mod, here is the link
http://www.buelletinboard.com/forums...ead.php?t=8677
Nitto12Ss,
What is the round canister on the left side behind the oil cooler???
That is the California emissions canister.
That looks really clean compared to my stock Ss... I think I'll tackle this project myself too. Thanks a lot!
Also, where can I get a front end "gas mask" like that?
It's an Avon gas mask that can be found on Ebay. About 1/2 down this thread page, Typeone who had the same, talks about fitment on his bike and gives a brief explanation: '05 Buell XB12S
Edit: It's after Polo's posts.
I did a diy write up on that mask to over at Buelletinboard.com
http://www.buelletinboard.com/forums...ead.php?t=7891
So is there anything that you would do differently a second time to make it go smoother, etc.? I just purchased a set of s rails and the under tray and a crumby seat that i can use the pan to fiberglass a fighter seat on. I already have subframe spacers that will fill the gap and hopefully the covers will line up. Did you have any difficulties fitting everything under the seat?
Sorry boltt01, I haven't looked at this thread for a while. The only problem/setback I ran into was the seat release cable. The S cable is about 4" longer than the Ss so I had to order one. As for fitting everything under the seat it requires you to get a little creative, but everything I did was mentioned above. Hope that helps and sorry it took a month to get back to you
Post pic's when done
Walter
Bike looks great, plus that right side scoop looks ****ing cool, it really beefs up the bikes chest.. Tight ass seat. Why did you go white with the headers? Does it keep them cooler or something?
Headers are silver,and they are there for looks only.
Sorry it took so long to reply, I haven't been on the forum in a while.