Results 1 to 3 of 3

Thread: Looking at 1125r. Going into gear problem

  1. 10-20-2016, 02:48 PM #1
    800screws
    800screws is offline
    Senior Member
    Join Date
    Jan 2014
    Posts
    128

    Looking at 1125r. Going into gear problem

    The bike is a 08. Owner says sometimes it takes a couple tries to get into gear from neutral but no problems going gear to gear. Does that sound like a clutch actuator problem. That seems the only issue on crutches dealing with a issue like that. Any ideas?
    Reply With Quote Reply With Quote
  2. 10-21-2016, 02:34 PM #2
    Cooter
    Cooter is offline
    Senior Member Cooter's Avatar
    Join Date
    Dec 2012
    Location
    Crawling up your skirt
    Posts
    10,895
    Or air in the lines. Does it creep forward in first gear with the clutch pulled in? I'd bleed it and do the actuator upgrade. I bet you'll be fine.
    Reply With Quote Reply With Quote
  3. 10-26-2016, 11:41 AM #3
    Cosworth
    Cosworth is offline
    Senior Member
    Join Date
    Jan 2014
    Posts
    1,318
    My 2008 1125R did the same when I first got it, fresh fluid and bled the lines good and it got much better. Still a bit clunky getting in and out of N but fine otherwise.

    I did recently have to replace the OE actuator with the EBR unit because of the infamous fluid leak but thats a easy procedure


    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules