I had an oil cooler inlet line fitting break of in my oil pump housing and was able to find it at the local Williams oil filter store for $5. Tapped out the old threads. Used high temp thread lock. Snugged the fitting, making sure the angle was plum with the oil line. Used high temp thread lock on the other end of the fitting. Used a propane torch to cure the thread lock on both sides of the new fitting. About 2k miles later and no leaks on the new fitting. This may save you $150 instead of a new oil pump.
20160930_104828.jpg
20160923_194504.jpg
20160923_194501.jpg