Activity Stream

Scoop, air ducts, OE, Gloss, matte, plain or twill weave, your choice....

https://st-paul-harley-davidson-buell.myshopify.com/products/s0101-7aa-genuine-buell-header-all-2004-2010-xb12r-xb12s-xb12x-models-u7b You can...

Ok. So you wanted to wrap Over the emblem for a 3D effect. Gotcha. I think it would be possible to do, however I still don’t think it would turn...

Preferences aside, it probably could be done if you're very meticulous and go slowly with the right tools, but I doubt it will it will turn out well....

The reason i want to keep the logo is that i think it would look cool, kinda 3D But i can be sooo wrong?!?

Thanks to all! Attached is what happens when the muffler band comes off, the bung hitting my boot (and the noise) alerted me that things had gone...

Are you just not wanting to remove the emblem? You want to wrap Around it? If that’s the case then don’t waste your time. It will look absolutely...

Because it looks rad with a tail lift and an extended swingarm. Ask Cooter.

I’m trying to understand why you would want to wrap the cover with the logo still on. Enlighten me

Has anyone wrapped airbox with the Buell logo still on? Thinking of do mine in carbon but it looks pretty hard.

If you have a stock muffler you can jack the bike up. Or remove the muffler and jack from underneath the engine. That’s what I did.

You could find a tall A-frame ladder and straddle it over the bike. Use that to lift up the tail. Same idea if you have sturdy rafters in the...

Hey gang, My fuel pump rebuild kit arrives here tomorrow! In anticipation for the job I'm wondering if any can provide some advice on how I could...

Very nice! One of my favorite things about Buell-dom is the interchangeability to suit my mood:angel:

I did the same thing NJ, but it backfired and 2 of her 3 bikes are in my garage right now...

Both Q3 had tire carcass problems early on :eek:

And you have the option of plug-n-play ECM from IDSpd.com for a proven tune in an ECM to match whatever muffler option you go with.

Have previously replaced the ECM due to being cracked at the connectors, fat guy on the seat so I did the ecm lowering mod, with new fan logic. Also...

Dean Adams builds his own beautiful exhausts (IMO),hence his "no comment" on rev-mo. Rev-mo appears to be the cheapest option that may hold up...

Ok, did a pre-flight check with the motor NOT running and everything works. Also cut the front center and middle out of the plastic bracket on the...

Glad your O.K. that must have really hurt ! Though I didn't break anything, I have a pretty good idea of how you felt, rear ended in June this...

Welcome to the forum, best of luck with the bike. Pictures or it never happened !

Stainless does fatigue and breaks down over time. IMO better off getting it new, not expensive...

That is a great bike. Nice color too.

Well thats good to know, mine is cracked due to the muffler clamp breaking so I need to replace, if they are all stainless then a used one would...

Lol. The stock header *IS* stainless steel. No comment on the rest of the parts you want to buy from them.

34-Figured Cooter would be burning up the track this weekend. Do not know where I got the idea you were in Santa Cruz. Phoenix is not too far...