Activity Stream

Still looking for a few parts to finish my project. I have the tail, seat, back-rest and lic.plate fender. I need the trunk pan, battery box and seat...

Hi yes I did try thr fuel cut on thr drummer map but I am now back on stock map and haven't done the fuel cut. O took the bike for a half hour run...

That tire will be fine to go through tech fabio!!!!

Woooow thank you for all that photos above! They are amazing:) I got satisfactory watching this
!!

It was farting all over my nice swing arm and tcs wire. So old exhaust coupler off my Camaro and BAM no more black fart on my stuffs..

You’ll have to come up again Kenny. Looking forward to it.

Do you still have these parts?

"Focus groups" are simply manufacturers pandering to a very small cross section of volunteers, hoping for an answer they like. Not "always"... and...

You are changing things much too quickly. Set the ECM to the way thats closest to the way you like it to run, and don't touch it for 200 miles. I...

The 19mm Brembo is fine for the ZTL2 caliper. I'm with Lunatic though, I believe its a lever problem. Do you have OEM levers on the bike? If...

"down in Homer" Not a lot of people get to say that! Especially riders.....

Thats a big tip!!!!

That justs means the focus group decided to trade off the sound and balanced the motorcycle mostly to the performance side. Focus group is always...

for the love of God TEABAG would you stop with your incredibly annoying trolling and consistently incorrect opinionated bull****. it's now beyond...

For the most people from the Buell motorcycle buyers group.

OK try this. With the bike warm and idling, wiggle the key and wiggle the Kill switch, take the seat off and wiggle the relays by the fuse box too.

Lots of guys at the Rock store have knee puck that look like they did that! LOL

Well, facually speaking, it is to them.

So basically Buell XB stock muffler has the best sound which is possible to produce with Buell XB engine. This sound has been picked by a focus group...

NO! the XB fuel tank gas cap will not fit your blast. that's the bad news. the good news is that the below factory part # is the locking cap for most...

Locking cap from a M2 will fit

I know that trick

You tell em lunatic .

^^ ^^^^^ If I didnt know any better that looks like it the wear is from being under inflated tire ???

NO street rider in 'merica rides further, rides faster or corners harder than i do. and all this on budget-priced Shinkos! i'll take all comers.

Good call njloco! Thanks :) Once I've figure this all out, I'll definitely do a second pass with the right lube on the right screws/bolts to make...

Hahahha omg that’s great!!!!!!! That car is a clapped out turd!! He blew it up thinking he could put a turbo on it with no tune