Activity Stream

Greetings Markus

Thanks for the offer. All available locally except the fuel level sensor. I can live with that though.

My pleasure. IMO it would be foolish to go to all this expense and effort and NOT replace the 2 large housing O-rings...drain plug O-ring...fuel...

Thanks Barrett. On my wife's I replaced Pump, FPR and filter last year, so I'll just do the same again here. Bosch pump, filter from HD and FPR from...

I dont suppose anything should be leaking out the top of the pump, so I can assume its time for a new pump? CORRECT Simply do a full rebuild....

So I finally had a chance to pull the pump assembly. Here is a video of the pump running in a bucket of water. (yes I did run fuel through it again...

that's a nice bike Markus, I got that same Franks German tail on my 12R.. I love what you did

still got BOTH Buells and running them several times a week.. I Really been thinking about a Harley though.. I like that Fat Bob and I like the new...

pls see previous post for more info. below is pic of new gates 82mm tensioner wheel. notice the mounting stud position in its elongated hole. in...

Glad to hear you're still riding, ain't it cold up thar!? You must have an electrically heated toque:black_eyed: That is a LOT of rain, but...

-Not sure what I wrote that made you think I have installed 2 new front rotors. I have only installed one new EBC front rotor. I did clean original...

Damn Gloom Welcome back Haven't seen you in a while. nice to hear your are still kicking and still own a Buell

Yes indeed! Thanks again for sharing your awesome journey w/ us. Great pic.'s

Rebuilding my pump on my '07 today, I noticed a couple of tiny nicks in the wiring as shown in some of the photos in this post. I also noticed the...

Bringing one back from the dead, I know. I pulled the fuel pump from my '07 Uly today, planning on rebuilding it with the kit purchased from...

Unfortunately yes, all the failures I have seen with this (my own '06 and at least 4 or 5 I have done for other people) all started with the female...

Holy heck man, that looks awesome. I can't even fathom what that scenery looks like on person. Thanks so MUCH for posting!

I took the old VR and hit it with connector cleaner, both connectors... plugged it in and 14.4! . I got my deltron battery tender pigtail in there...

I haven't been on for while but looking through your saga here I would be inclined to suspect the dear old 77 connector that is the DC output of the...

sonofabitch ... I plug in my old VR before pulling the one off my 07 and the old one is charging at 14.4 V.... plug in my new eBay copy and it's...

,I'm gonna try and plug in my VR that's on my 07 and if it fixes it we will know..

but continuity shows why the stator isn't putting out power.. mine IS putting out the power it needs so continuity is ok, or that was my...

Yeah I need to apologize for not having you circle back to ensure you're following all the troubleshooting steps. Barrett is correct - ANYTIME you...

I didn't do continuity, just saw that the output was good , I figured the continuity was just to isolate if the stator or rotor was bad.. and if...

is 12.6V at the battery while at idle enough to charge this battery? NO Your initial "stator check" was incorrect....then you figured it...

in the northwest part of Slovenia, near Krankska Gora is the highest pass in the country, Vrsic Pass ( https://maps.app.goo.gl/rR3mrApVrNoZdFuK9 )....

I'm getting confused.. at rest , reading across my battery terminals is 13.1V.. at idle its 12.6V if you rev it up to 4000rpm it doesnt go up much...