PDA

View Full Version : Injector connections



buellyssesxt
05-08-2010, 11:29 AM
Hi, I'm wanting to fit a Remus Powerizer to run with a modified exhaust.
My problem is that due to the location of the injector connections I can't see how to release them and I obviously don't want to break them as they aren't the easy to release spring type.
Any suggestions greatly received.

buellyssesxt
05-18-2010, 10:43 AM
Sussed.
The trick is a pair of long nosed pliers and a gentle squeeze and the connector is released. Job done. Thanks to Matt at Adrenalin Moto for confirming how the connectors release.

chrispudd
05-18-2010, 11:24 AM
Just squeeze the two tabs at the top of the injector and pull. Keep and eye out for the rubber weatherpak seal that sits inside the plug-in. If it falls out just poke it back in. They re easy to lose..