View Full Version : Other XB exhaust cans fit the Uly?

06-30-2010, 02:11 PM
Will other XB exhaust cans fit the Ulysses? XB12R can looks similar.

06-30-2010, 02:24 PM
Yes. The 9 pipes won't have the valve though, so you would need to disable that in ecmspy or plug in an emulator.

06-30-2010, 04:18 PM
Thanks Miami78, there are more cans off XB12R's for sale than off XB12X uly's and I wannted to confirm they are the same.

06-30-2010, 04:47 PM
Which exhaust is on your bike now? If it is not using the servo now you'll need to check and make sure you still have the cable that connects from your servo motor to the muffler if you put a stock exhaust back on.

06-30-2010, 06:18 PM
Its a Stainless Drummer so no valve. The cable is disconnected but still have it so I could hook a stock back up.

06-30-2010, 06:25 PM
Oh good, you are good to go then.

06-30-2010, 07:06 PM
so can the servo be disconnected without changing anything else when changing to aftermarket exhaust.

Once disconected what did you guys do with the cable, remove it, tuck it away, etc...

06-30-2010, 07:10 PM
Zip tied to something else down at the bottom, tucked the upper portion under the seat (on my lightning).

06-30-2010, 10:16 PM
Doesn't the kickstand on a Uly hit the exhaust tip on a regular 9/12 can?

07-01-2010, 06:35 AM
I have one with a notch that has been fabbed in to the design. I am pretty sure it is stock.


07-01-2010, 01:13 PM
I was wondering do they fit as far as attachment and header alignment and it sounds like they do. If the kickstand interfers a little I can grind that notch, thanks for the heads up. I think I read that the Ulysses muffler has thicker metal on the bottom or some sort of internal reinforcment added for bash resistance? I saw a Uly where the guy welded a strip of plate along the bottom to prevent dents when sliding over rocks etc. It looked hell strong!

07-01-2010, 02:13 PM
All the XBs have reinforced mufflers. They are the stock jacking point on the bike.