PDA

View Full Version : torque kit ???



buell007
03-15-2008, 02:15 AM
where in the name of little baby jesus can I buy one of these;) and one qoute from ricky bobby ,

His_and_Her_Buells
03-15-2008, 03:07 AM
I'm guessing you are refering to putting a XB9 primary gear and chain on an XB12. This yields and 11% increase in torque, of course at the cost of an 11% reduction in top speed. If this is what your refering to then americansportbike.com (http://www.americansportbike.com/) has them for around $200, or any Buell dealer should be able to get it. Of course this is of no use if you have an XB9.

buell007
03-15-2008, 03:11 AM
well poop[down] thank you.[cool]

His_and_Her_Buells
03-15-2008, 03:30 AM
You could always do a chain conversion and pick the right size sprocket to give you the same effect on your 9. Might cost closer to $300 though.

buell007
03-15-2008, 05:10 AM
I might just do that im having a problem with my bike at 4900 to 5000 it falls falt but if i twist it more it pulls. I read A post that had sim problems.

let me giv e my set up 2007 xb9r race ecm jardine and k&n. this started about 300 miles ago . ill be riding ant normal speed and rpm but if i hold the throttle at 5000 it stumbles sorry about the spelling. but if i give it more throttle it goes away. i HAVE NO CHECK ENGINE LIGHT or other issues

LeFox
03-15-2008, 10:14 AM
reset your ecm...this is not a normal.

there are tourque kits & different sprockets available for the xb9. but that won't change the problems you're having.

buell007
03-15-2008, 03:33 PM
thank you how do you reset the ecm. or does the dealer have to do that

LeFox
03-15-2008, 05:21 PM
- find a dealer
- find someone with ecmspy (http://www.ecmspy.com/) or other software
- get ecmspy (http://www.ecmspy.com/)

buell007
03-16-2008, 03:25 AM
would a tps cause these symptoms

LeFox
03-16-2008, 10:17 AM
well...dunno, hard to say [smirk]

what do you mean with stumble?
is it always at the same rpm?

buell007
03-16-2008, 02:59 PM
yes if i hold the throttle at 4800-5000its pops a little out of the exhaust and drops of a little inthe rpms but only at that rpm.

LeFox
03-16-2008, 09:14 PM
if it wasn't like that before, a reset could be the solution.
but then again, there could be other reasons.

shortyxb12r
03-17-2008, 02:23 AM
What's up with ecmspy? What does it do for you. I have the race ecm.Will it help me?What do you gain from it?Thanks

justice720
03-17-2008, 05:57 AM
buell007:
yes if i hold the throttle at 4800-5000its pops a little out of the exhaust and drops of a little inthe rpms but only at that rpm.

well don't hold it there.. lol sounds like a tuning issue..

buell007
03-17-2008, 12:44 PM
tuning? like what in specific i have the race ecm. k&n filter, and jardine

LeFox
03-17-2008, 02:10 PM
you'll probably get to much fuel round that rpm range.
if you did not have it before...a tps reset should resolve it. before doing this you could maybe try and clean the k&n filter, cheap and may help a little bit.

but reset your tps, let the ecm learn again and i think your problem will be solved. ;)