PDA

View Full Version : Help! Please? Exhaust header issues



Buellove
10-01-2010, 02:25 PM
Ok. So, I recently got an exhaust system for my 2009 xb9sx. I purchased a jardine rt-1 carbon. During installation of this exhaust I discovered that my header was cracked. Finished the install and bike was running fine...so, I thought. Rode the bike for a few days with a cracked header and new exhaust as my dealer person said it would be ok. Get the new header installed yesterday and now my bike runs like poo! So, im not gonna run it until I figure out what I'm doing as I don't want to tear anything up! What is wrong? What do I need to do? ECM? Remap? Take it to dealer? Do it myself? Please help as I'm kinda new to all this! Any help is appreciated!

Miami78
10-01-2010, 02:27 PM
TPS reset.

Miami78
10-01-2010, 02:31 PM
To reset an 08+ Buell, do the following:
1. Turn on the key.
2. Set the kill switch to the run position.
3. Don’t start the engine. Rotate the throttle from fully closed (gently forced closed) to fully
open (gently held open), and then back again to closed (gently forced closed).
4. Repeat 3 times. Hold each position (fully open, fully closed) for 1 full second.
5. Turn the key off and on.