PDA

View Full Version : whats required help



partmanpartbike64
03-27-2008, 01:34 PM
I can have an end can taylor made, that looks the part & will sound good, but it's not going to run right therefore i now need to know what ec/unit will work on a uk spec 06 ully as it's going to need a fuel remap and KN filter I would appreciate any advice you all could give as i've been told US parts are differently set up humidity and such

LeFox
03-27-2008, 02:34 PM
remaps stock, that's all you need.

here's some literature: click (http://www.buellxb.com/Buell-XB-Forum/Buell-Firebolt-XB12-XB9-2008-1125R/ecm-required-with-a-slip-on)

partmanpartbike64
04-08-2008, 05:39 PM
thanks chap but found out i can have a free replacement (ceramic endcan) from buell as they have accepted that the can should not be in the state it's in at 3000mls also they have said that a number of models have been sold with poor coatings on the can and therefore are eligable to be replaced free of charge! however i found that trogan horse do a remus electrickery thingy that allows buells with after market zorsts to run right £198

LeFox
04-08-2008, 08:38 PM
i don't pay that much for a remap, though [smirk]

scobbie001
04-08-2008, 10:38 PM
LeFox, I've never had a remap done, exactly what all do they do, and about how much should it range in price? I know it's going to vary for you across the pond, but I'd like some idea in case I have to go through with it.

Thanks.

LeFox
04-09-2008, 08:13 AM
LeFox, I've never had a remap done, exactly what all do they do, and about how much should it range in price? I know it's going to vary for you across the pond, but I'd like some idea in case I have to go through with it.
they hook your ecm on a computer, reset tps, place your bike on a dyno, load a tested map, make a run, see what points need adjusting, make a run, fine-tune and make a final run.

normally it should be done in 3 runs with a tested map. if they don't have one, more runs could be needed.

price, i would say between 200$ & 250$...if i'm not mistaking, someone on here had it done for 220$.

scobbie001
04-09-2008, 01:23 PM
Thanks! :)

LeFox
04-09-2008, 01:52 PM
http://smile.smilies.nl/382.gif