View Full Version : Testing cam position sensor??
0311devil
06-29-2011, 10:41 PM
How do I test it? I cant find anything in the service manual. What are the testing procedures?
wolfo68
06-29-2011, 10:58 PM
jack the back wheel up, pop it into 5th and rotate to check if it's at 0 v or 5 v when the front is coming up on compression and looking through the viewer
0311devil
06-29-2011, 11:01 PM
I dont understand. Already tested 5 volts at the plug. But how to I test the actual sensor
wolfo68
06-29-2011, 11:08 PM
you mean if it's working correctly? or if it's set right?
0311devil
06-29-2011, 11:11 PM
To test if its shorted out
wolfo68
06-29-2011, 11:13 PM
I believe it should throw a code
0311devil
06-29-2011, 11:21 PM
Only codes I have are injectors. But my pump amd fuel pressure are good. Injectors ohmd out perfect too.
wolfo68
06-29-2011, 11:31 PM
I'm not sure what all the causes are for injector codes, but did you check all the wires to see if anything wore out?
0311devil
06-29-2011, 11:46 PM
yeah. And I dont think its the ecm because I still have power to the injector plugs..just no pulsation
wolfo68
06-29-2011, 11:57 PM
well if nobody else chimes in by when I get to work I'll crack open a manual
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.