View Full Version : Drumer SS Servo question
xtreme
07-10-2011, 08:50 AM
So I got my Drummer SS in and I removed the exhaust servo cable. Should I remove the box on top of the air filter and if so, what about the wire harness going to it. Thanks.
jakestolar
07-10-2011, 08:58 AM
I zip tied the cable out of the way by the exhaust. I did not remove the box on the air filter
xtreme
07-10-2011, 09:05 AM
sound good. It only took me about 5 minutes to remove the cable completely. Thanks.
freak2180
07-10-2011, 09:14 AM
Same here..... Tied back cable and left servo plugged in and in place.
stellio78
07-10-2011, 11:00 PM
Just so you know if you remove the servo actuator with the standard ECM fitted you will get a fault light.
I have a EBR ECM and removed the servo actuator and cable but just to tidy up the area, I taped the end of the electrical connector and tucked it in near the side of the frame.
http://i345.photobucket.com/albums/p394/stellio78/Buell/PICT0076.jpg
xtreme
07-11-2011, 05:40 AM
Thanks Selio thats exactly what I needed. I have the EBR ECM
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.