PDA

View Full Version : Cams



RHYNOXB9R
08-21-2008, 02:22 AM
Ok,everyone has done the airbox mod,slip-on can,and ECM mod to get the Buell breathing right.Has anyone played with the cam selection?There are some good cams from Jims and Screaming Eagle,anyone have any input?BPG?[confused]

BuellPartsGuy
08-21-2008, 02:41 AM
Zippers Red Shift Cams... They have a few to choose from.

buell007
08-21-2008, 03:52 AM
what cams would you recomend for 1 to 2 stages above stock

BuellPartsGuy
08-21-2008, 04:39 PM
Check out their website. They tell you the recommended set ups for each cam.

dans03firebolt
08-21-2008, 05:34 PM
I will have to check out their website. I would like to get some more power out of my 9 and cams would definitely help.

dans03firebolt
08-21-2008, 05:37 PM
I went to their site and it only shows 80" and up motors. I don't even know how big in CI the 984cc motor is. I emailed them I am waiting for a response.

Bordsnbikes
08-22-2008, 01:23 PM
It's 60 ci.

Bordsnbikes
08-22-2008, 02:02 PM
I just put cams in my sportster, they were by andrews cams and i went with the N2 Grind. It's a step above stock and you can use your stock lifters and pushrods because they open for a longer duration instead of opening more. Perhaps call andrews and see if they are compatible or what they have for a Buell.

firechickenXB9R
08-22-2008, 06:35 PM
Don't you have to pull the motor to put cams in?

dans03firebolt
08-22-2008, 06:40 PM
You most certainly do. Now if it was a 88" twin cam I am pretty sure you don't need to pull the motor. But the sporty style motors need to come out.

Bordsnbikes
09-28-2008, 12:47 PM
No you don't need to pull the motor. I bored my cylinders and installed cams all with the case in the frame. You will have to be able to lift the lifters though so you can slide the cam in. So you either need to remove the rocker box, or with some creative thinking and a buddy rock the rockers open and you will have barely enough room to get them in.