PDA

View Full Version : 1125 mirrors fit xb12r?



troyford417
09-06-2008, 01:50 AM
I would like to know if the mirrors from a 1125 fit a 04 firebolt. I am thinking of replacing turn signals with l.e.d.s. If mirrors fit, can i hook up the signals to factory signal wires?

BuellPartsGuy
09-06-2008, 01:56 AM
Yes, they will fit. You will have to get creative with the wiring. Its not too hard.

gbalias
09-06-2008, 07:26 AM
dont forget your EP-26 relay.

firechickenXB9R
09-08-2008, 06:08 PM
I have them on my 03 XB9R wiring was very easy. Drill a 5/16in hole in between the two post holes thenrun your wire down on the inside and plug them in. The relay is only needed if you don't like how fast they flash, it will slow them down. Good look it is a great mod, those LED's are crazy bright.

loser54023
09-09-2008, 12:08 AM
what did you do where the old turnsignals were?

Lordfenwick
09-09-2008, 09:15 AM
you can use these:

http://www.trojan-horse.co.uk/prods/61.html

firechickenXB9R
09-09-2008, 08:35 PM
Going to make some billlet blanks. I will post pic when I get it done.

FIDOSOL
09-09-2008, 08:40 PM
Permanent solution is to bond-o it and paint to match...

06xb9r
09-10-2008, 01:16 AM
The turn signals are part of what holds the fairing on. It may be best to find some nice looking bolts to put in there.

fastxb12r
09-11-2008, 10:58 PM
been there ===>1125 mirrors (http://www.buellxb.com/Buell-XB-Forum/Buell-Firebolt-XB12-XB9/my-new-1125-mirrors-on-my-xb12r)