PDA

View Full Version : aftermarket turn signal problem



RenXB
09-22-2008, 06:30 AM
today i swapped out the stockers for some aftermarkets. front ones replaced no problem, flashed just right. although the males on the new ones didn't plug into the female stock with a perfect fit (too skinny), so taped them together.

then i go to replace the rear sets. not enough wire either side to reach the females. i cut off the stock males and connected them to the rear wires to extend them, and connected everything perfect. then i test them out and whichever side i blink stay solid and it makes a wierd noise, any ideas?

and by the way, how the heck do u take the bulb out of the tailight?

LeFox
09-22-2008, 11:05 AM
relay is getting to much voltage, change it and your problem is solved.

your aftermarket blinkers need less power to work.

see following posts for more info:
click 1 (http://www.buellxb.com/Buell-XB-Forum/Do-It-Yourself-Buell-Mods/custom-turn-signals), click 2 (http://www.buellxb.com/Buell-XB-Forum/Buell-Lightning-XB12S-XB12Ss-CityX-XB12Scg/Troubleshooting/Turn-signal-is-buzzzzing....), click 3 (http://www.buellxb.com/Buell-XB-Forum/Buell-Firebolt-XB12-XB9/Blinkers-Wont-Blink), click 4 (http://www.buellxb.com/Buell-XB-Forum/Buell-Firebolt-XB12-XB9/Help-with-light), etc... (http://www.buellxb.com/index.php?a=search) ;)

firechickenXB9R
09-22-2008, 05:40 PM
rear light comes out by pulling the lens off.

BryD959
09-22-2008, 06:53 PM
http://www.americansportbike.com/shoponline/ccp0-prodshow/16086.html