PDA

View Full Version : 2001 buell blast



colt hicks
05-11-2012, 02:51 PM
i have a 2001 buell blast,when i got the bike it would run til it got hot then die.i changed the auto enrichener and solved the problem.i rode the bike for 2 days then it sat over night.now it will start and run 15-20 seconds and die.if you turn the key off then rite back on it will start back up and do the same.i changed coil,ignition control module,voltage reg.,plug,plug wire,ignition switch,enrichener,intake boot,rebuilt carb.still dies after 15 seconds.can anyone help me out

ghostedrider
05-11-2012, 06:17 PM
check the front engine ground it will cause lots of problems if loose, then check the lights on the ignition module see if they flash correctly, check the timing, try replacing the gas it may be bad or may have plugged a jet, disable the kickstand safety, flip the center clutch safety diode / the safety's cause lots of intermittent problems

remove the gas cap when it stops running it may not be venting corretly

pierce
05-11-2012, 07:23 PM
All good advice.

And by ignition control module do you mean ignition? Did you purchase the stock ignition?

colt hicks
05-11-2012, 07:51 PM
im about to go check that ground and diode.i'll let you know what i find.thanks!

colt hicks
05-13-2012, 09:17 PM
i have checked all the things that you have listed plus some,and still nothing.any other ideas,bank sensor?crank sensor?i have been building bikes for 20 years and never seen no crap like this!