swingarm sliders

[BryanXB12R]

i saw these today at work and i was wondering if i could use them as sliders. Does anybody know the radius of the axle.
http://www.speedwaymotors.com/p/1538,321_Weld-Bungs.html?itemNo=91002967

[xtremelow]

sure can I did something very similar but just machines some at work out of aluminum on the lathe. Then just get some threaded rod and cut to length.

[Bill2]

Those would be way too heavy. The store bought sliders only use about 1/4" dia. treaded rods too keep the unsprung weight down.

[xtremelow]

There is no unsprung weight to keep down since the axle is hollow. Plus I doubt the steel will add even a pound so if the weight was rotational it would only figure out to be an additional 3-4lbs anyway.