View Full Version : 1125R Handlebars

07-12-2009, 03:53 AM
I am wondering if any one knows where I can get handle bars that would put me in a more upright position for my 1125R? I have a set for my Honda CBR but I haven't found very many part/aftermarket parts for the 1125r yet. Any information on where I can get more parts for my Buell would be awesome. Thanks in advance.

07-12-2009, 08:06 AM
Marcello supply┬┤s the US-market also

07-13-2009, 04:44 AM
If you were to get the CR triple tree, you could do the CR high bar conversion. It should total around $350


link (http://www.buell.com/en_us/gear/accessories/product.asp?Menu_ID=2&ProductLineID=1&CategoryID=7&ProductID=4275)

07-19-2009, 04:55 PM
I just put a set of Convertibars on mine. They are adjustable and they are great. www.convertibars.com

11-14-2009, 02:13 AM
I am planning on trying the lightning upper triple clamp, this weekend. I know the 1125's use larger forks but the upper clamp measures the same so I will give it a try, and let you know how it goes.

11-14-2009, 03:37 AM
my biggest concern would be bar clearance around the fairing... wouldn't a higher mounted bar hit the fairing?

11-16-2009, 02:31 AM
Update, the Lightning upper triple clamp fits fine. I will begin work on combining the two ignition switches soon. (also a concern with using CR stuff, the ignition switch would be mounted on about a 45 degree angle coming out the right side)

11-21-2009, 07:09 AM
I found some other info on one of these boards indicating that there is a difference in width between the 1125 and the XB triple clamps. I will check into it and post a few pics soon. The superbike style bars I installed on a Lightning upper triple clamp, allow the master cylinders to clear the fairing. Here are a few part numbers for others doing higher bar conversions.
N0307.1AT throttle cable
N0308.1AT "
N0103.1AT clutch line
(all parts for 2010 1125 CR with standard high bars)

11-21-2009, 09:49 AM


the bars are stainless steel, so you could take them to a metal shop, and have them do this for you with a MIG welder, preferably.

04-15-2010, 04:21 AM
This is an old threadl, but I will post this anyway. Maybe it helps someone. Here is one solution with some good pics:


04-17-2010, 10:46 AM
Thanks John, I check every once in a while to see if any one has added to the thread. I am due back in the states in Oct, I have been gone for a couple years, I will probably get the high bars then. Thanks for the reply.