PDA

View Full Version : Ok Guess it is time i need help xb9 flashing check engine light



RT Performance
07-25-2009, 02:18 AM
road about 25 miles bike seemed kinda weak but nothing terrible. go in store come out start and check engine light is flashing [sad]
ride to othe store across lots light still flashing.
go in store 10 minutes ish coem out flashes back to other store.
another 10ish stop
Decide to expressway home instead of risking 2 lanes
Light flashing all the way i think it was 9 flashes but they where fast about halfseconed then a 2 second pause and flash agian.
I get home turn bike off 20 minutes in the house grab lappy hook up spycable and says no codes present [smirk]
starts stalls
cranks backfires
cycle kill switch
starts runs no light or codes
I can't get the light to come on
and it ran fine flashing all the way home and cooling fan ran cool down after i heated it up and ripped up the drive and back.
i noticed the cam sync signal was un check for set code for in ecm spy.
Does this sound like a cam sensor?
Thanks
Rt

RT Performance
07-25-2009, 03:43 AM
I just want out ran it agian pulled the seat the battery terminals where little loose.
looked everythign else over i had washed it maybe 2 hours before i left i hope it was just a mositer batt terminal problem guess i have to go ride the piss out of it tomorrow to be sure (oh Darn)

TooFst
07-25-2009, 06:59 PM
My batt. comes loose all the time. Any one out there with starting issues check the terminals 1ST I think its because they shake so much