PDA

View Full Version : Headlight conversion



skin
09-10-2009, 06:39 AM
I would like to change the single headlight unit on my 2001 M2 Cyclone to a duel set up. Is this possible and could anyone point me in the right direction?

pur pony
12-09-2009, 04:18 AM
here is my bike with the XB dual headlights. I used the XB housing, windscreen, and lights. Made some aluminum spacers and drilled and tapped a could 1/4-20 holes and bolted it on. The dash is a custom one off piece i designed and built to hold my factory gauges, but i have heard of others using the XB gauges.....

http://www.buellforums.com/forum/photoplog/file.php?n=471&w=o

tuneport67ss
12-09-2009, 12:58 PM
That is one good looking tuber. [up]
THe headlight really makes the bike. I have never been a big fan of the single light. Might have to look into one of these for a second bike and change the front out.:p

aaronbuell
12-09-2009, 03:08 PM
I like the look makes your bike look newer than it is.

pur pony
12-09-2009, 08:29 PM
thanks, it will look even newer once I install the XB Forks, Wheels, and ZTL brake next week.

aaronbuell
12-10-2009, 05:00 PM
I've been thinking of doing an xb front end switch on my S3 like ophawk did made the bike look alot different. What did the switch cost you if you don't mind me asking. What parts have to be made to fit?

pur pony
12-11-2009, 04:39 AM
I have not fully collected all the parts needed but i have most. So far i have a set of 03 XB forks $108 (which are supposed to fit my stock triple tree), a 1125 rear wheel $85 , XB rear 65t pulley $15 , xb rear brake disk $12, front XB Uly wheel $76.... I still need a front disk, caliper, and 29t front pulley.

Also, i tried ordering the rear custom HAL spacers i need to install the XB rear wheel on the tuber axle but they no longer make or sell them. I will be making my own most likely. Just have to finish up my measurements.