Tab Content
  • pdksh's Avatar
    07-17-2019, 03:38 PM
    pdksh replied to a thread Noisy Girl in Buell 1125CR
    i Have sourced a used 2008 motor with apparently 5000kms but getting ahold of the seller is challenging. I'll give him a week to get his act...
    24 replies | 702 view(s)
  • pdksh's Avatar
    07-17-2019, 01:26 PM
    I found a socket for $1.49 at a local surplus store, spent 10 minutes cutting it down on a bench grinder. The switch metered funny, with spiking...
    8 replies | 215 view(s)
  • pdksh's Avatar
    07-12-2019, 02:25 PM
    I have a very similar issue on my XB12X. It started when not starting when pressing the starter button when in neutral, without pulling in the...
    8 replies | 215 view(s)
  • pdksh's Avatar
    07-10-2019, 07:41 PM
    pdksh replied to a thread Noisy Girl in Buell 1125CR
    I was thinking an air-cooled conversion may run a little smoother :-) Im down to one sick motorcycle now. I left the best for last. I do have to...
    24 replies | 702 view(s)
  • pdksh's Avatar
    07-09-2019, 07:58 PM
    pdksh replied to a thread Noisy Girl in Buell 1125CR
    I have sourced a low mileage motor locally for a fair price. I'm going to pick it up this weekend. My motor has 25,000KMs and I'm buying a crashed...
    24 replies | 702 view(s)
  • pdksh's Avatar
    07-09-2019, 01:40 PM
    pdksh replied to a thread Noisy Girl in Buell 1125CR
    It's not good. Not good at all!!! Last night I finally rotated the motor... The first obvious sign that things weren't good on the front cylinder...
    24 replies | 702 view(s)
  • pdksh's Avatar
    06-25-2019, 02:28 PM
    pdksh replied to a thread New S3T owner in Buell X1, M2, S3
    I replaced the brake pads on both of my tubbers. The old pads had some sort of issue, age, contamination or just glazing. The new pads, especially on...
    16 replies | 508 view(s)
  • pdksh's Avatar
    06-20-2019, 01:01 PM
    Yes my trip was cut short. I did trailer the bike home after going for a couple of good runs after replacing the wheel bearings. I could have taken...
    14 replies | 572 view(s)
  • pdksh's Avatar
    06-20-2019, 12:35 PM
    did anyone mention the primary cover clutch ramp? On all of my buells the clutch ramp shows various degrees of wear. If it has been mentioned, I...
    20 replies | 6009 view(s)
  • pdksh's Avatar
    06-20-2019, 12:04 PM
    pdksh replied to a thread Tubber cafe racer! in Buell X1, M2, S3
    Cafe Racer Update... Well on my way now. Paint is done and I had the swing arm polished. Next is polishing of the tail section and I need to clean up...
    9 replies | 1037 view(s)
  • pdksh's Avatar
    06-20-2019, 11:54 AM
    Just a couple of quick updates :-) I never like threads that end without full resolve... Nothing like reading about the exact same issue your bike is...
    14 replies | 572 view(s)
No More Results

1 Visitor Messages

  1. View Conversation
    thank you for the very kind words as i appreciate them greatly. yes on dealership folks and parts counter people in particular. these souls don't make all that much money and you can only imagine what dealing with the public and in particular some of these H-D people must be like. they're just trying to eek out a living like the rest of us.
Showing Visitor Messages 1 to 1 of 1
About pdksh

Basic Information

About pdksh
Location:
Ontario
Interests:
Buells

Statistics


Total Posts
Total Posts
197
Posts Per Day
0.20
Visitor Messages
Total Messages
1
Most Recent Message
04-10-2017 08:47 PM
General Information
Last Activity
Yesterday 02:14 AM
Join Date
11-02-2016

2 Friends

  1. Cosworth Cosworth is offline

    Senior Member

    Cosworth
  2. lunaticfringe lunaticfringe is offline

    Senior Member

    lunaticfringe
Showing Friends 1 to 2 of 2