Tab Content
  • pdksh's Avatar
    07-17-2019, 03:38 PM
    pdksh replied to a thread Noisy Girl in Buell 1125CR
    i Have sourced a used 2008 motor with apparently 5000kms but getting ahold of the seller is challenging. I'll give him a week to get his act...
    24 replies | 695 view(s)
  • pdksh's Avatar
    07-17-2019, 01:26 PM
    I found a socket for $1.49 at a local surplus store, spent 10 minutes cutting it down on a bench grinder. The switch metered funny, with spiking...
    8 replies | 207 view(s)
  • pdksh's Avatar
    07-12-2019, 02:25 PM
    I have a very similar issue on my XB12X. It started when not starting when pressing the starter button when in neutral, without pulling in the...
    8 replies | 207 view(s)
  • pdksh's Avatar
    07-10-2019, 07:41 PM
    pdksh replied to a thread Noisy Girl in Buell 1125CR
    I was thinking an air-cooled conversion may run a little smoother :-) Im down to one sick motorcycle now. I left the best for last. I do have to...
    24 replies | 695 view(s)
  • pdksh's Avatar
    07-09-2019, 07:58 PM
    pdksh replied to a thread Noisy Girl in Buell 1125CR
    I have sourced a low mileage motor locally for a fair price. I'm going to pick it up this weekend. My motor has 25,000KMs and I'm buying a crashed...
    24 replies | 695 view(s)
  • pdksh's Avatar
    07-09-2019, 01:40 PM
    pdksh replied to a thread Noisy Girl in Buell 1125CR
    It's not good. Not good at all!!! Last night I finally rotated the motor... The first obvious sign that things weren't good on the front cylinder...
    24 replies | 695 view(s)
  • pdksh's Avatar
    06-25-2019, 02:28 PM
    pdksh replied to a thread New S3T owner in Buell X1, M2, S3
    I replaced the brake pads on both of my tubbers. The old pads had some sort of issue, age, contamination or just glazing. The new pads, especially on...
    16 replies | 500 view(s)
  • pdksh's Avatar
    06-20-2019, 01:01 PM
    Yes my trip was cut short. I did trailer the bike home after going for a couple of good runs after replacing the wheel bearings. I could have taken...
    14 replies | 570 view(s)
  • pdksh's Avatar
    06-20-2019, 12:35 PM
    did anyone mention the primary cover clutch ramp? On all of my buells the clutch ramp shows various degrees of wear. If it has been mentioned, I...
    20 replies | 6007 view(s)
  • pdksh's Avatar
    06-20-2019, 12:04 PM
    pdksh replied to a thread Tubber cafe racer! in Buell X1, M2, S3
    Cafe Racer Update... Well on my way now. Paint is done and I had the swing arm polished. Next is polishing of the tail section and I need to clean up...
    9 replies | 1037 view(s)
  • pdksh's Avatar
    06-20-2019, 11:54 AM
    Just a couple of quick updates :-) I never like threads that end without full resolve... Nothing like reading about the exact same issue your bike is...
    14 replies | 570 view(s)
No More Results
About Cosworth

Basic Information

Statistics


Total Posts
Total Posts
1,310
Posts Per Day
0.65
General Information
Last Activity
Today 01:42 AM
Join Date
01-21-2014

2 Friends

  1. mrlogix mrlogix is offline

    Senior Member

    mrlogix
  2. pdksh pdksh is offline

    Senior Member

    pdksh
Showing Friends 1 to 2 of 2