-
These are almost done, I am having one last minor change made and then it will go into production. It's been through a couple of revisions now and I'm at the point where I'm pretty much ready to pull the trigger on it and have them made. They're a little bit beefier than the jardine set in some places and slotted to allow for mild fitment differences between bikes.
I do not have a 100% firm price yet, but it will definitely be under $100 a set shipped. (Edit, they're $85 shipped, powder coated in black only)
They will be powdercoated black and have all the nuts/bolts needed to install on any XB. Obviously some nuts will be re-used, such as the pulley, but the small ones will be included.
http://i643.photobucket.com/albums/u...423_170343.jpg
http://i643.photobucket.com/albums/u...423_172344.jpg
http://i643.photobucket.com/albums/u...423_172411.jpg
http://i643.photobucket.com/albums/u...423_172306.jpg
If you wish to get a set, post here or send me a PM.
-
SWEET! I can finally revisit exhausts that don't allow for a chin fairing
-
I'd like a set as you know
-
Good job Dean!
-
I will probably do an inital run of 10 or so. I already have 2 claimed, even without a firm price.
-
I know mine will fit perfectly.
-
Very cool Dean
-
How far off is the R&D for a belly pan bracket for the 1125? :D
-
GOOD and CLEAN job !!!!
:)
-
Count me in. This will make my bike look great again.