Clear answer, thanks! That is exactly what I meant.
Printable View
hey! hello everybody:afán:
in Xaloc from spain, and no speak english:trastornado: i have a two buells, xb12s (before scg) and 1125R with CR apparence.
I have participated a lot in the Spanish Buellmotards forum, but I am new here because I have a lot of problems with English (sometimes I use a translator)
I have installed shifter on both bikes, but the 1125 does not work. I thought the shifter would connect to the BAS connector, wouldn't it?
I have connected between negative (GND), and pin 3 of the gray connector. The xb does fantastically well (it has a map of twinmotorcycles is the ECM), but the 1125 does not cut the spark (it has an EBR map with an engraving "RACE USE ONLY").
What's the problem????
Is the quickshifter function turned on in the ECM?
They normally come that way. Just needed to check.
Does the grey wire show ground when you activate the shifter?
Attachment 13489
this is my invention
With the bike running and the wheel raised, I shift into second gear and spin it. I connect a direct cable from the negative of the battery to pin 3, and it does nothing.
The leg lateral sensor is activated (here it is mandatory), but if it is deactivated it does not cut either.