baro sensor enabled eeprom?

Anybody have a baro sensor enabled eeprom for the BUEID (2007 XB12S) firmware?

Dodge, the Baro sensor activation isn't part of the fueling program or the firmware, it's an ECM Parameter. You are able to toggle it on or off regardless of what firmware or fueling program you have.

Whatever setting it has will carry over on the eeprom file from wherever you got it. So if it's 'off' from there, it will be 'off' when you load it on your ECM. Just turn it back on.

Yeah, was able to set it up using the latest ver of ESpy on my 08 and verified it is working by applying either pressure or vacuum to the sensor. But, cant seem to get it up and working on the 07. Have enabled it via ECMDroid, but still a no go. Was hoping to source a complete eeprom for the 07 with it confirmed and functioning properly.
thanks cooter

I'm not sure what you're up to dodge. I don't understand what you mean by "Have enabled it via ECMDroid, but still a no go". Does that mean you can't see it on live data? With no info from you, it sounds like a wiring issue in baro circuit in the '07.

Trying to tackle this once again.. Got the 08 working fine with the baro sensor using ecmspy mono. Trying to do same with the 07, but there are greyed out areas in the 07 settings via mono. The settings options that I can not enable are: "Read sensors continuously" and "Use baro pressure (not MAP) sensor" Can't enter anything into the "Static air pressure stored value" window as well.