Richer Fuel Map for standard XB
Thanks John. That does not sound like a great recommendation for that map especially since it is from a 2008 which I understand to be a totally different ECM from that on our 2006/2007 bikes. Thanks for the heads up. I was just about to go the Buelltooth route, primarily to get that map, after frustration with ECMSPY.
Cooter, your comment is interesting because with the EBR Race module, I found a real flat spot below 3000 RPM. It improved when I wired the exhaust valve open but then the mid range seeemed to suffer. I got hold of a 2004 stock ECM and replaced the pooched exhaust valve actuator and when I finally got the TPS done right that setup seems to work better than the EBR. Is there a way to get the EBR fuel map to work with the exhaust valve on the stock pipe? Now the bike seems to be running as god intended, i probably shouldn't mess with it, but i guess there is always room for improvement. Might try the ecmspy to make sure there is enough fuel at idle and WOT. Or just buy a Drummer and get the EBR module reflashed to match.
I am new to this forum and really impressed with the level of technical knowledge here. John, really appreciated your piece on grounding the XB series, which i happened to see first on the Badweather site.