Search:

Type: Posts; User: dreygata

Search: Search took 0.02 seconds.

  1. Replies
    9
    Views
    282

    Alright I got it fixed. Ended up getting a...

    Alright I got it fixed. Ended up getting a buelltooth dongle, and ran ecm Droid to see what was up. All but the ETS sensor were historical. So one new ETS later, and I'm doing no more errors and it...
  2. Replies
    9
    Views
    282

    Well it appears that I tested my coil incorrectly...

    Well it appears that I tested my coil incorrectly and it's actually fine, so I ordered a part for no reason. So now I'm back at square one, except I have a Bluetooth dongle I can read the codes and...
  3. Actually, nevermind. It looks like I'm confusing...

    Actually, nevermind. It looks like I'm confusing my shocks. The one I have has the cone thing on it, which is just a safety device, and the replacement I'm looking at doesn't.
  4. Rear Shock Mounting Bracket Differences?

    Are there any differences in the mounting brackets between the original rear shock on the 2000 X1 and the recall/upgraded one? Or can I straight swap them?
  5. Replies
    9
    Views
    282

    I've never constructed a new plug wire before, so...

    I've never constructed a new plug wire before, so that'd be new to me. The front wire seems to be lacking holding power on the coil side. The rear has a definitive "snap" noise when plugged in,...
  6. Replies
    9
    Views
    282

    Ok, so I tested the coil. on the wiring harness...

    Ok, so I tested the coil. on the wiring harness side, the two outer pins measure 1.3 ohms (primary), and the two pins that connect to the plug wires measure 11.5kohm (secondary). Both of these seem...
  7. Replies
    9
    Views
    282

    I just ordered the BuellTooth dongle so I can...

    I just ordered the BuellTooth dongle so I can check out the ecm stats.
    I pulled the sparkplugs last night, and they were black and sooty, so it's running rich. They were cheap champion plugs, so I'm...
  8. Replies
    9
    Views
    282

    Thanks. I tested the resistances of the ETS and...

    Thanks. I tested the resistances of the ETS and IAT last night, and the both seemed in spec for their values at roughly 60F. However, I couldn't get an accurate reading for the ETS once the bike was...
  9. Replies
    9
    Views
    282

    Replacement Sensors for X1?

    Hi everyone, this is my first Buell, an '00 X1, and I'm trying to get it running better.
    I jumped the two pins on the diagnostic port and I'm getting codes for a bad engine temperature sensor, IAT,...
Results 1 to 9 of 9