Search:

Type: Posts; User: Stevenc150

Page 1 of 20 1 2 3 4

Search: Search took 0.33 seconds.

  1. Replies
    5
    Views
    1,122

    I'd start simple & change Spark Plugs - NGK#...

    I'd start simple & change Spark Plugs - NGK# DCPR9EIX. Then move on to the technical stuff...

    ...changing Spark Plugs
  2. Replies
    113
    Views
    143,583

    Buell Relays - (Autozone) Duralast Pt # 19283

    Buell Relays - (Autozone) Duralast Pt # 19283
  3. Replies
    22
    Views
    2,289

    Of course he'll need to drain the oil or it'll be...

    Of course he'll need to drain the oil or it'll be pouring out the clutch cable hole while he's swapping them out. Wiggle2
  4. I started out on a Buell too and it's definitely...

    I started out on a Buell too and it's definitely not the easiest starter bike. Trust me and enroll in an MSF course before you dump it again. ;)
  5. Replies
    3
    Views
    1,607

    1: Open your Stock EEPROM with ECMSpy in one...

    1: Open your Stock EEPROM with ECMSpy in one window so you can see your Map/Timing Values.

    2: Open the Maps you want on your ECM in another ECMspy window. (Much safer this way than trying to...
  6. Replies
    788
    Views
    350,412

    I run mine with no catch can, no problems, with...

    I run mine with no catch can, no problems, with an open end. Zip tied the open end under the LH footpeg neatly and get a few droplets on the side of the swingarm ever so often.
  7. Replies
    30
    Views
    4,217

    Then the plugs aren't the problem. White wire...

    Then the plugs aren't the problem.

    White wire mod is for 9's only. Not sure about domestic/foreign.
  8. Replies
    18
    Views
    4,869

    The stock Harley battery is a great choice. It's...

    The stock Harley battery is a great choice. It's made to turn over these big V-twin beasts.
  9. Replies
    30
    Views
    4,217

    Some people have reported issues with the NGK...

    Some people have reported issues with the NGK 8's. The DCPR9EIX is the correct plug though the 8 does work fine for a few.
  10. Replies
    30
    Views
    4,217

    You still should be able to ride it at a steady...

    You still should be able to ride it at a steady RPM (2500-3500); regardless of Idle.

    "Learn-in" ride is when the ECM goes into closed loop (monitoring) mode - Taking a long ride holding at a...
  11. Replies
    30
    Views
    4,217

    You need to do a Learn-in ride. Take a nice long...

    You need to do a Learn-in ride. Take a nice long steady cruise @ a steady RPM. (Assuming you had the right wire & a good TPS reset.)
  12. Replies
    788
    Views
    350,412

    ^Agreed^ Eventually, those would stop up with...

    ^Agreed^ Eventually, those would stop up with gummy crud, depending on how much your's splurges.
  13. Replies
    20
    Views
    4,211

    - DIY - Removing Headers w/o Rotating Engine...

    - DIY - Removing Headers w/o Rotating Engine

    - DIY - Header Removal w/o Engine Rotate with Pics

    - DIY - Header Pull Youtube Video

    ...and ceramic coating is fairly inexpensive.
  14. Replies
    20
    Views
    4,211

    Hot Air travels faster. Ceramic coating...

    Hot Air travels faster. Ceramic coating evacuates (dissipates) the heated exhaust gases faster because ceramic doesn't absorb & transfer the heat like uncoated steel or even chrome. This means...
  15. Replies
    6
    Views
    1,730

    Have it checked under Load at any Auto Parts...

    Have it checked under Load at any Auto Parts store - it's free. You can't go by static readings when checking batteries. Hope it's that simple. If still checks good, post back up...
  16. Replies
    25
    Views
    15,273

    Check gaps at the counter and keep swapping until...

    Check gaps at the counter and keep swapping until you get a set that is properly gapped - then pay for them.
  17. Thread: New Member

    by Stevenc150
    Replies
    25
    Views
    2,392

    Welcome to the Board. :D

    Welcome to the Board. :D
  18. Replies
    281
    Views
    178,985

    Also there's Buellmods.com - Downloads section

    Also there's Buellmods.com - Downloads section
  19. Replies
    4
    Views
    1,306

    Heat Shields...

    Heat Shields
  20. Replies
    5
    Views
    1,429

    Use the passenger peg from the opposite side so...

    Use the passenger peg from the opposite side so it won't flip up on you.
  21. Replies
    2
    Views
    1,086

    NO! They are different firmwares for those 2...

    NO! They are different firmwares for those 2 year models. It'd be better to just load the Race ECM mappings onto your current ECM AFTER saving a copy of it for back-up. Do not physically take an...
  22. Replies
    10
    Views
    1,588

    Troubleshooting: Stator OR Voltage Reg....

    Troubleshooting: Stator OR Voltage Reg.

    Edit: Troubleshooting for both is also outlined in the Service manual. Grab one off of Buellmods.com if you haven't already
  23. Replies
    6
    Views
    1,034

    ^ ^

    ^ ^
  24. Replies
    10
    Views
    1,484

    I personally have Pazzos. But any high quality...

    I personally have Pazzos. But any high quality aftermarket, including those above, are an AWESOME upgrade over stockers.
  25. Replies
    6
    Views
    2,150

    Buell Cross Reference Thread ...

    Buell Cross Reference Thread ;)
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4