Just sold my Blast today so have a box of extra parts. Parts are located in Alcoa, TN (just outside Knoxville)
rear shock
front pegs
rear brake line/ switch
rear fender/ plate/ tail mount...
Type: Posts; User: cgborders
Just sold my Blast today so have a box of extra parts. Parts are located in Alcoa, TN (just outside Knoxville)
rear shock
front pegs
rear brake line/ switch
rear fender/ plate/ tail mount...
Sold!!
2001 Buell Blast 500cc single cylinder
6K miles.
Tons of work into getting this thing set up:
Custom Flame Paint job
Custom exhaust system with Carb jetted to match
K&N air filter
Clubman...
Finally (after 2 years of sitting) I've got my 2001 Blast up and running. But have an issue- after I bought it I had to rebuild top end due to a bent valve and damaged piston. I've got it put back...
So after messing with swivels, different extensions, etc. pulling the shock made getting to them very easy. 3 minutes to remove the shock is well worth it.
I"m trying to pull the foot peg Y brackets to start working on my rearset. I've seen somewhere a post talking about a trick / technique to remove them but can't find it now. Any suggestions? I can...
New to the Blast but worked on lost of other bikes, sounds more like idle circuit of carb that intake boot. I'd pull the carb and clean it. Replace the pilot jet while your in there (about $4 at...
Update: after few hold-ups and a cross country move the bike is finally back together and running. No issues with head so far, carb seems to be pretty close.
Few questions- I've never owned or...
So I'm working on my budget rearsets. question I have is with regards to the shifter splines. Are there other bikes that will fit? I know some are using XB shift linkage but those seem pretty...
Nice looking setup but way too rich for my budget. I like how close in it sits.
I've seen lots of guys removing the airbox and putting on a cone style filter but can't find any details about the swap. Anyone have a detailed explanation/ instructions?
I know I'll have to rejet...
Got it assembled today, turned the motor over by hand... the piston comes up and stops as it hits the head!!! Its the wrong one!!! So had to tear the motor back apart. New piston is on its way.
...
Where are you located?
Quick update, got the head getting rebuilt as we speak; should be ready tomorrow. The piston is being replaced, small mark from valve. More worrisome however is the rear edge of the piston is...
There is an exhaust stud that is broken so pipe was not seating well. My theory is that caused the valve to burn/stick. The pushrod bent pressing against valve.
Would this issue damage lifters or...
So I bought a 2001 Blast Yesterday with 6k miles on it.
Story goes the previous owner was riding it, loud backfire, bike died. He was not able to restart it.
I picked it up and started...