Search:

Type: Posts; User: Foldout

Search: Search took 0.07 seconds.

  1. Wait, the primary plug's tiny magnet was covered...

    Wait, the primary plug's tiny magnet was covered in shavings so the rotor's magnets are probably covered too. Didn't think about that at the time. Man, I'll have to take out the clutch, chain, and...
  2. It's got the factory bolts on the flanges: one...

    It's got the factory bolts on the flanges: one side is socket cap allen, the other is hex head. Nice tip with the fuel line for the rear. Swapping the plugs and wires myself is fine, maybe even the...
  3. First off thanks for the suggestions! Back to...

    First off thanks for the suggestions! Back to share what I found:

    Front cylinder spark plug cable was loosely connected on the coil side. The terminal was broken and rusted. New cables on order....
  4. New concern, what seems like an excessive amount...

    New concern, what seems like an excessive amount of lukewarm air and oily mist is continually exhausted through the positive crankcase ventilation breather tube (I removed the mini-airfilter for...
  5. First contact! You're too kind Cooter. Just...

    First contact! You're too kind Cooter.

    Just reset the TPS again (before I saw your reply). I did follow the procedure each time, should've clarified. Then went for some short errand rides. First...
  6. 06 Ulysses XB12X stalling on cold startup and at warm idle

    Bike:
    Recently purchased 2006 Ulysses XB12X, 18.5k miles, K&N air filter, breather re-route with filter, Termignoni exhaust without valve, stock BUEIB ECM (no idea if the map is stock).

    Problems:...
  7. That light gray connector is the speed sensor...

    That light gray connector is the speed sensor connector. The #77 voltage regulator connector is the black 2-wire connector behind the rest, see this diagram from the manual:
    14308
Results 1 to 7 of 8