It only happened after 30 min or so but my headlight would go off then come back on. It would only happen at low rpm like at stoplights or stopsigns. It made me think the votage regulator was failing...
Type: Posts; User: twobuells
It only happened after 30 min or so but my headlight would go off then come back on. It would only happen at low rpm like at stoplights or stopsigns. It made me think the votage regulator was failing...
The electrical diagnostic manual has a troubleshooting checklist of steps to follow if your turn signals fail. The book was less than 60 $ and easy to read in the garage while looking at your bike.
Someone had to buy the Buell part to get the ford part #. It may take some work to adapt the one on ebay to fit your buell.
Actuator showed up today. It's made by FoMoCo if someone knows ford #3l3e-9g730-ea that no stamped on part. The cable bracket is no longer cast into the part but now a bolt on piece. I'm not saying...
Thanks for the generous offer but I already have one coming in the mail. Will buy a aftermarket exhaust before buying another actuator.
Put a new back tire on last week and took a good look at the belt. At 34500 miles it was cracked between every tooth on the belt. Installed new belt purchased last year and looked at the wheel...
You need to know the part no needed to use their site but where else can you find traction grips #55959-02Y. If the listing is current lots of hard to find parts. NOS parts.nl
Is the result of the motor co telling dealers not to sell discounted parts to resellers?
Could be wrong but I thought they had number on gas cap no. ooo of 500.
Get on badweb. Go to xbrr and look at a 3.6 case.
Just over eight in. Hard to measure complete assembly.
I ran silver stars for the time it took to burn out the 2 I bought. They last about 3 months.
Several dirt trackers have raced at pikes peak. Your supposed to be successful in amateur racing before moving on to first year pro otherwise known as novice class. Unless the rules have changed you...
Sale on Michelin at motorcycle superstore up to 47% off.
The best way I found to adjust the belt is to use a motorcycle tie down and a straight edge. On my X1 remove the seat run the strap over the subframe and fasten to both sides of the swingarm. Tighten...
It looks like the first weekend it didn't rain. They usually run out of food early then close up.
Every one is pre 2008.
1200 sportster has same stroke. Could be a xb9 crank?
The old trick that works on tubers is to run with oil level right between the full and low marks. If the oil is all the way to the top mark unless you checked it hot it will blow oil out the vent.
If my remember it was three psi vacuum for 5 min. It would be easy to make using the exaust flange gasket and a rubber cork with a hole to stick a nipple in for the carb flange. Yes a mighty vac ...
To test a two stroke for leaky crank seals you need a vacuum tester and a block off for the intake and exaust.
Just a guess but your ecm may be cracked. If you can wiggle the terminals where the harness plugs into the ecm it probably is the cause of your problems. The longer you ride the seat base heats up...
Stoped by Surdyke today to order a belt for the ULY. They have one black and one red EBR on the showroom floor. The black one has a crack in the fairing that I was told happened in the crate so maby...
Handlebar part # N0037 4AKBP
Delran the people who manufacture battery tender brand are now making lithium batteries. The 300 cca weighs just over 2 lbs has a 3 yrs warrenty with first year 100% replacement and retails for...