Search:

Type: Posts; User: C2H5OH

Page 1 of 2 1 2

Search: Search took 0.04 seconds.

  1. Replies
    1
    Views
    761

    Primary adjuster bolt stripped

    It's raining, so I haven't been able to really look at it. It's good that it rained though, because I was putting the cover on and noticed a large oil spot. Otherwise, I would've hopped on and went...
  2. Replies
    23
    Views
    2,573

    Finally got it to idle by messing around with the...

    Finally got it to idle by messing around with the idle screw. So it will die if I give it a little throttle, but the RPMs shoot up when I give it a hard twist.

    https://youtu.be/D1R6zmFKjPA
  3. Replies
    23
    Views
    2,573

    Hmmmm. I tried to start it a day before I made...

    Hmmmm. I tried to start it a day before I made this post and my bike would hardly crank. I put the battery on a charger. Never crossed my mind.
  4. Replies
    23
    Views
    2,573

    Will any Android phone work? Are there minimum...

    Will any Android phone work? Are there minimum specs?
  5. Replies
    23
    Views
    2,573

    I'm going to start with the TPS reset. I don't...

    I'm going to start with the TPS reset. I don't have a laptop to take outside to connect to my bike. Any chance there's a way to do it with an iPhone? I searched for ECMSPY for iPhone and nothing...
  6. Replies
    23
    Views
    2,573

    Link to that thread?

    Link to that thread?
  7. Replies
    23
    Views
    2,573

    That was my first assumption. Would the TPS just...

    That was my first assumption. Would the TPS just suddenly go bad?
  8. Replies
    23
    Views
    2,573

    2004 XB12R w/40K miles. Race ECM. Not sure of the...

    2004 XB12R w/40K miles. Race ECM. Not sure of the exhaust. Bought it a year ago and ran fine.
  9. Replies
    23
    Views
    2,573

    Not like that. More like it runs out of gas.

    Not like that. More like it runs out of gas.
  10. Replies
    23
    Views
    2,573

    It doesn't die abruptly. Just slowly dies.

    It doesn't die abruptly. Just slowly dies.
  11. Replies
    23
    Views
    2,573

    Won't run more than about five seconds.

    So bike starts right up and idles fine for about five seconds, then dies. If I start it and give it throttle, it will throttle up normally for about five seconds, then die. After it dies, I can hear...
  12. Replies
    5
    Views
    1,152

    Found the culprit. At some point the bike had...

    Found the culprit. At some point the bike had HIDs and they were wired in to the air box. But didn't bother to secure that block of metal that was bouncing all over the place.

    7559
  13. Replies
    5
    Views
    1,152

    Somethings loose and it's driving me crazy

    2004 XB12R Something is banging every time I hit a bump. The front isolator was worn out and I replaced it. Headers and muffler aren't broken. I've checked everything and can't find anything loose....
  14. Replies
    4
    Views
    1,173

    I have another question I just thought of. I'm...

    I have another question I just thought of. I'm used to the bulbs having a two wire connection and this uses one wire with the base being the ground. It looked like there was one ground wire running...
  15. Replies
    4
    Views
    1,173

    Thanks. It had Germany stamped on it. Thought I...

    Thanks. It had Germany stamped on it. Thought I was going to have to special order some $200 light bulb.
  16. Replies
    4
    Views
    1,173

    What is this wizardry?

    So both headlights blew out and the hi beam indicator light stayed on. I messed around with the wiring looking for a short and found nothing. Finally unplugged the hi beam bulb and the lo beam came...
  17. Replies
    8
    Views
    1,295

    Almost 40K. Every time I hit a bump it felt like...

    Almost 40K. Every time I hit a bump it felt like something was loose. The tensioner was slamming in to the bolt head.
  18. Replies
    8
    Views
    1,295

    I cranked it pretty hard. When I was putting the...

    I cranked it pretty hard. When I was putting the new one on I had to loosen it up because the engine was too high to line up the bolts. I would do it again if I had too knowing that it doesn't take...
  19. Replies
    8
    Views
    1,295

    Did my front isolator today.

    Took me forever to actually find one, but one finally popped up on eBay. Took me about a total of 20 minutes. Couldn't believe how easy it was. I don't have a jack, so I used a crank strap. I...
  20. Replies
    7
    Views
    1,435

    I'm going to replace mine tomorrow. What size hex...

    I'm going to replace mine tomorrow. What size hex socket do the bolts take?
  21. Replies
    8
    Views
    4,777

    Thanks Rays. I did pull the diode while checking...

    Thanks Rays. I did pull the diode while checking all the fuses. Went out and tried flipping it around, didn't work. Put in a spare fuse and it worked. Then I put the diode back in and everything is...
  22. Replies
    8
    Views
    4,777

    Relay issue solved. Now a problem with neutral....

    Relay issue solved. Now a problem with neutral. Used to be able to start in neutral while on the side stand, now I have to pull the clutch while in neutral.
  23. Replies
    8
    Views
    4,777

    Can I get a link to that?

    Can I get a link to that?
  24. Replies
    8
    Views
    4,777

    Where to buy relays?

    So I got stranded today. Tail light and oil light came on, but nothing else. Did some searching on my phone before calling a tow truck. Came across a forum post about switching the relays. I swapped...
  25. Replies
    15
    Views
    2,295

    Bare with me. Newbie to Buell. Made a post not...

    Bare with me. Newbie to Buell. Made a post not long ago about a squealing noise when accelerating hard. I also feel like something is loose every time I hit a bump. Could all these be related?
Results 1 to 25 of 33
Page 1 of 2 1 2