Search:

Type: Posts; User: Mito

Page 1 of 2 1 2

Search: Search took 0.39 seconds.

  1. Replies
    10
    Views
    801

    Hey Lunatic, thanks for that clarification on the...

    Hey Lunatic, thanks for that clarification on the importance of the ECM being grounded well. This miss/stutter in the mid range has plagued me since I purchased the bike at 30ks. Some days the bike...
  2. Replies
    10
    Views
    801

    Hey Lunatic, thanks for that. I had already added...

    Hey Lunatic, thanks for that. I had already added more grounds to the bike. From the coil mount to the steering head, coil mount to the other side of the top engine stay and yes, coil mount to the...
  3. Replies
    0
    Views
    257

    Buell Fan Replacement

    Hey Everyone, thought I would share my experience of replacing the fan on my 07 Ulysses but would be the same procedure for any XB Buell. As covered in a previous thread, a SPAL 5.2 Pusher fan, part...
  4. Replies
    10
    Views
    801

    Hi, yes the erratic miss is in that range and...

    Hi, yes the erratic miss is in that range and only on a steady light load throttle. It is not continuous, just occasionally in the first 30km of any run then it seems to settle. AFV is 105%. I would...
  5. Replies
    10
    Views
    801

    Yep, done all that, new plugs and leads, new...

    Yep, done all that, new plugs and leads, new intake seals, injectors, new TPS, coil and extra grounds around the bike. Did all this as a 70km freshen up which was pretty inexpensive.
  6. Replies
    10
    Views
    801

    Ulysses a bit snatchy through trans

    Hey Everyone, my Ulysses has just clocked over 70,000kms so have freshened up a lot of parts to see if I can eliminate a minor engine miss. Miss does clear after around 30km so looks like it is a...
  7. Replies
    57
    Views
    21,837

    Thanks John, I swapped a couple of the leads to...

    Thanks John, I swapped a couple of the leads to the non shakey side and sprayed a bit of water dispersent around the terminals. Took it for a run after a TPS reset and yes, there was a noticeable...
  8. Replies
    57
    Views
    21,837

    Hey Guys, I know this post is quite old but I...

    Hey Guys, I know this post is quite old but I have recently been chasing a intermittent miss fire and uneven running on my 07 Ulysses. Problem was, I had a couple of issues going on at once. Main one...
  9. Thread: De Potting a ECM

    by Mito
    Replies
    4
    Views
    475

    Cheers, Cooter, I got a near new unit off ebay at...

    Cheers, Cooter, I got a near new unit off ebay at a good price so my old one is just a play around unit. Keen to get more experience with the electronic side of Buells. Stu
  10. Thread: De Potting a ECM

    by Mito
    Replies
    4
    Views
    475

    De Potting a ECM

    Hey Everyone, just wondering if anyone has experience of de potting and extracting the innards of a ECM. The ECM on my Uly developed an intermittant fault of losing power to the fuel pump and it...
  11. Replies
    3
    Views
    492

    XB Throttle Body vacumn tube

    Hey Guys, just going over all of my bits on my 07 Uly before I start reassembling. I have been chasing low speed rough running for a bit so eliminating possible causes as I go. I noticed a brass tube...
  12. Replies
    5
    Views
    1,040

    Hi, I have found Pin-Wall Cycles in the states a...

    Hi, I have found Pin-Wall Cycles in the states a reliable and reasonably priced source for Buell parts. Cheers, Stu
  13. Thread: XB Injectors

    by Mito
    Replies
    6
    Views
    627

    Thanks Lowkey, lots of info to take in. Yes the...

    Thanks Lowkey, lots of info to take in. Yes the Adrenalin R muffler is just a stainless straight thru system that I have fitted. The rough running issue was present with the previous owner using the...
  14. Thread: XB Injectors

    by Mito
    Replies
    6
    Views
    627

    Hi, cheers for that. Not so much blind...

    Hi, cheers for that. Not so much blind replacement but eliminating all of the low cost variables first to establish a base point I can work from. Did a TPS reset using Buelltooth. AFV was reading...
  15. Thread: XB Injectors

    by Mito
    Replies
    6
    Views
    627

    Hi, it's a 07 with Adrenalin R muffler otherwise...

    Hi, it's a 07 with Adrenalin R muffler otherwise stock. Issues were reported by previous owner before any mods made so has been around for a while.
  16. Thread: XB Injectors

    by Mito
    Replies
    6
    Views
    627

    XB Injectors

    Hey Guys, giving my Ulysses a good going over at the moment. I have been chasing some low speed rough running issues for a while now so eliminating a lot of potential causes by replacing bits with...
  17. Replies
    12
    Views
    1,560

    Back in the 70's I was quite into Triumphs and...

    Back in the 70's I was quite into Triumphs and Nortons. The Tridents and Commandos I owned were only a couple of years old and parts supply was pretty erratic. I eventually moved onto Ducatis and now...
  18. Replies
    22
    Views
    1,735

    To be fair, our roads in NZ South Island are...

    To be fair, our roads in NZ South Island are pretty rough at the moment due to the earthquakes and alternate routes and detours needed, quite often on roads never designed to take the load so getting...
  19. Replies
    22
    Views
    1,735

    Hey Cooter, actually, parts supply is pretty...

    Hey Cooter, actually, parts supply is pretty good. We must have more rubbish on our roads out here as on a recent rally, 3 belts got broken including mine, hence the discussion. Fortunately I had a...
  20. Replies
    22
    Views
    1,735

    Emergency Belt Joiner

    Hey Guys, been a bit of discussion over here in NZ about emergency belt joiners. Is there such a thing or urban myth disguised as wishfull thinking. Cheers, Stu
  21. Thread: XB9r wiring loom

    by Mito
    Replies
    1
    Views
    379

    XB9r wiring loom

    Hey Guys, I have a 03 Firebolt xb9r that was purchased with frontal accident damage and wiring loom has been sheared off upfront and broken relay boxes. I was able to get a mint loom off a xb12r...
  22. Thread: Ulysses Fuel pump

    by Mito
    Replies
    2
    Views
    1,022

    Ulysses Fuel pump

    Hey Everyone, took the Ully out the other day and ran her a bit dry on fuel. After refuelling, I noticed she would die a slow idle till it stopped and the fuel pump seems to have a different noise...
  23. Replies
    4
    Views
    1,082

    OK, any idea what ecu's across the Buell range...

    OK, any idea what ecu's across the Buell range will plug into a 07 Ully. Don't care about the map, just the compatibility of the plugs etc. Cheers, Stu
  24. Replies
    4
    Views
    1,082

    Hi, looking at buying a spare ecu for reflashing...

    Hi, looking at buying a spare ecu for reflashing my Uly. Are all ecu's the same or are there differences that will trip me up. Cheers, Stu
  25. Thread: Ulysses issues

    by Mito
    Replies
    13
    Views
    2,489

    Hi Everyone, just removed both wheels on the Ully...

    Hi Everyone, just removed both wheels on the Ully for a tyre change and found the juddering front brake problem. Disc side wheel bearing was on the way out big time. Obviously, when the brake was...
Results 1 to 25 of 44
Page 1 of 2 1 2