Alright I got it fixed. Ended up getting a buelltooth dongle, and ran ecm Droid to see what was up. All but the ETS sensor were historical. So one new ETS later, and I'm doing no more errors and it...
Type: Posts; User: dreygata
Alright I got it fixed. Ended up getting a buelltooth dongle, and ran ecm Droid to see what was up. All but the ETS sensor were historical. So one new ETS later, and I'm doing no more errors and it...
Well it appears that I tested my coil incorrectly and it's actually fine, so I ordered a part for no reason. So now I'm back at square one, except I have a Bluetooth dongle I can read the codes and...
I've never constructed a new plug wire before, so that'd be new to me. The front wire seems to be lacking holding power on the coil side. The rear has a definitive "snap" noise when plugged in,...
Ok, so I tested the coil. on the wiring harness side, the two outer pins measure 1.3 ohms (primary), and the two pins that connect to the plug wires measure 11.5kohm (secondary). Both of these seem...
I just ordered the BuellTooth dongle so I can check out the ecm stats.
I pulled the sparkplugs last night, and they were black and sooty, so it's running rich. They were cheap champion plugs, so I'm...
Thanks. I tested the resistances of the ETS and IAT last night, and the both seemed in spec for their values at roughly 60F. However, I couldn't get an accurate reading for the ETS once the bike was...
Hi everyone, this is my first Buell, an '00 X1, and I'm trying to get it running better.
I jumped the two pins on the diagnostic port and I'm getting codes for a bad engine temperature sensor, IAT,...