Search:

Type: Posts; User: RHYNOXB9R

Page 1 of 20 1 2 3 4

Search: Search took 0.20 seconds.

  1. Replies
    0
    Views
    608

    Does anyone have a header pipe for a 2005 xb12r...

    Does anyone have a header pipe for a 2005 xb12r motor in good condition they would to sell?
  2. Replies
    3
    Views
    807

    Hey Buellers,just finished the swap of putting in...

    Hey Buellers,just finished the swap of putting in a 05' xb12r motor into my 03' xb9r,also did the primary gear swap of the 9's into the 12,on Saturday had a 3 hour Dyno tune session at JTnS...
  3. Thread: ECM question

    by RHYNOXB9R
    Replies
    3
    Views
    741

    Great learning process, if your interested, on...

    Great learning process, if your interested, on the xb9r wiring harness, all electrical demands for the bike are connected, the xb12r and xb9r use 98% of the same parts, the terminal between the 2 ECM...
  4. Thread: ECM question

    by RHYNOXB9R
    Replies
    3
    Views
    741

    No, the ECM that I put on is for the 2005 xb12r...

    No, the ECM that I put on is for the 2005 xb12r motor that I also just put in, the ECM is from or came with the xb12r motor that is now in my xb9r frame, just wondering if that middle prong in will...
  5. Thread: ECM question

    by RHYNOXB9R
    Replies
    3
    Views
    741

    So I put the ECM from the xb12 on xb9, I noticed...

    So I put the ECM from the xb12 on xb9, I noticed that the ECM on the 12 has a plug inbetween the two main plug ins and my 9 didn't, is that something on the 12's only and will this affect anything...
  6. Replies
    1
    Views
    814

    Got it done, very tight tolerances, you must have...

    Got it done, very tight tolerances, you must have the chain, from the 9, on the front sprocket and the rear and slide them both on at the same time, not the easiest, but doable, then set proper chain...
  7. Replies
    1
    Views
    814

    Doing the xb9 primary gear swap into the xb12 and...

    Doing the xb9 primary gear swap into the xb12 and my primary chain form my xb9 is to short and the primary chain from the xb12 seems to long the xb9 primary gear and chain are from a 2003...
  8. Replies
    1
    Views
    841

    Once again, thank you Terry over at JT&S...

    Once again, thank you Terry over at JT&S PERFORMANCE, here in Sonoma County, he took time out of his busy day( its a race weekend ) to talk me through everything over the phone,Terry, YOU DA MAN...
  9. Replies
    1
    Views
    841

    Good morning ,I'm in the process of swapping a...

    Good morning ,I'm in the process of swapping a 1203 into my xb9r frame, getting to the point, the cam gearcase cover was cracked on the 12 so I went to take off the cover to put my 9's on, while...
  10. Replies
    6
    Views
    1,349

    Right on Kona,and Yes,im talking about the rear...

    Right on Kona,and Yes,im talking about the rear output shaft pulley that conects the belt to the rear sprocket,thank you on the info;)
  11. Replies
    6
    Views
    1,349

    Fock,did you do anything to lock the sprocket...

    Fock,did you do anything to lock the sprocket up,like the belt being on,although you did say you were tearing appart your motor, i just dont want to break anything in the tranny,and thanks for the...
  12. Replies
    10
    Views
    13,574

    Good info kd4gru,just did my pipes with the black...

    Good info kd4gru,just did my pipes with the black Dei wrap tonight,i have hi temp silicone spray and will coat them well,thanks for saving me from losing it;)
  13. Replies
    6
    Views
    1,349

    Ok,so I have to remove the rear tranny...

    Ok,so I have to remove the rear tranny sprocket,the manual tells of a "holding tool"don't have one,has anyone just taken the sprocket off with an air impact? And anyone know the size of the sprocket...
  14. Replies
    14
    Views
    1,500

    some of the older members on here will remember...

    some of the older members on here will remember back when mountainclimber and I did this swap,we were among some of the first,everyone thought it looked stupid,now it is a desired swap,they look...
  15. Replies
    406
    Views
    118,735

    Just ordered my right side air scoop kit from the...

    Just ordered my right side air scoop kit from the HD dealer,some of the prices in these posts,some dates 2009, have changed,the whole kit cost me $100.58 from the dealer,a lot more than listed in...
  16. Replies
    3
    Views
    945

    Looks like I will call JTnS up here in...

    Looks like I will call JTnS up here in Sonoma,CA,when they open,I'll post and let you guys know if their compateable;)
  17. Replies
    7
    Views
    1,279

    I would check out www.revolutionperformance.com...

    I would check out www.revolutionperformance.com they have some great big bore kits,have seen their 90ci kit on a xb12,total rocket,all depends on how much your willing to spend,you get what you pay...
  18. Replies
    3
    Views
    945

    Hey Buellers,I am in the process of putting an...

    Hey Buellers,I am in the process of putting an xb12r motor into my xb9r bike,I am also doing the primary gear switch on my 9's gear into the 12,since I have the rotor and primary gear from my 9...
  19. Replies
    2
    Views
    763

    Hey Buellers,in the process of doing a swap of a...

    Hey Buellers,in the process of doing a swap of a xb12r motor into my xb9r,came across this,has anyone else had this kind of wearing on your exhaust mount,I know it's from the oil lines rubbing...
  20. Replies
    43
    Views
    2,821

    Interested in your ecm if you still have it;)

    Interested in your ecm if you still have it;)
  21. Thread: ECM question

    by RHYNOXB9R
    Replies
    2
    Views
    671

    Can a ecm from a 2003 xb9r be used for a 2004...

    Can a ecm from a 2003 xb9r be used for a 2004 xb12r motor or are they different? I am swapping out the 9 motor for a 12. Thanks;)
  22. Replies
    7
    Views
    1,288

    Sweet oh9,I'm going to see if my local HD dealer...

    Sweet oh9,I'm going to see if my local HD dealer can get ahold of these today,this should be interesting,thanks for the info.
  23. Replies
    7
    Views
    1,288

    Has anyone bought one of America Sportbikes right...

    Has anyone bought one of America Sportbikes right side air scoops for their XB? Does it match well in size and looks to the stock left side scoop? Was thinking about buying one but thought I'd run it...
  24. Thread: Rim options?

    by RHYNOXB9R
    Replies
    0
    Views
    734

    Hey Buellers,my buddy is building a FXR,he put a...

    Hey Buellers,my buddy is building a FXR,he put a front end on that came from a later 90's X1,possibly a S1,swap meet find,question is,has anyone running this front end ever put on another type of rim...
  25. Thread: Fried clutch

    by RHYNOXB9R
    Replies
    4
    Views
    1,030

    Question is,would a smoked clutch pack cause the...

    Question is,would a smoked clutch pack cause the shifter to lock,or freeze up? As mentioned before in my clutch basket post,I was on the freeway,rolling 85mph,bike made funny lunging feeling,and then...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4