Search:

Type: Posts; User: butchcr

Search: Search took 0.09 seconds.

  1. Thread: charging issue

    by butchcr
    Replies
    12
    Views
    6,422

    "Charging harness" was that a recall issue? When...

    "Charging harness" was that a recall issue? When I got the bike there was a harness piece installed from a dealer recall I believe. Should i take that out?
  2. Thread: charging issue

    by butchcr
    Replies
    12
    Views
    6,422

    I agree! You have helped me in the past and I...

    I agree! You have helped me in the past and I really appreciate it, THANKS!!
  3. Thread: charging issue

    by butchcr
    Replies
    12
    Views
    6,422

    I will do that reset for the idle. Cleaned batt....

    I will do that reset for the idle. Cleaned batt. terminals real well, replaced back on. It all seems to run ok now. I made a mistake in saying 12.5v, at idle I am getting 14.3v. I was going to put...
  4. Thread: charging issue

    by butchcr
    Replies
    12
    Views
    6,422

    Idle speed is a little high, 1200rpms what is...

    Idle speed is a little high, 1200rpms what is normal? Dash has 12.5 volts. The day it was acting up it was around 100' out. Put the thing back together yesterday, about 80' out, bike acted normal. At...
  5. Thread: charging issue

    by butchcr
    Replies
    12
    Views
    6,422

    charging issue

    I changed the stator, rotor, voltage reg. on my 1125cr, rode 1k miles and batt. light comes on, rev it up a little it goes out. Rotor is an EBR, Rick's stator and Rick's hot shot voltage regulator....
  6. Replies
    7
    Views
    6,978

    Got it out!!! I did take off the fairing. Much...

    Got it out!!! I did take off the fairing. Much thanks for advice again.
  7. Replies
    7
    Views
    6,978

    Thanks again to all!! I will go with all the...

    Thanks again to all!! I will go with all the info. I get here! Have a great winter!
  8. Replies
    7
    Views
    6,978

    Battery Replacement for 1125cr

    ANY ideas on how to get the battery in/out of my 1125cr? Crazy small space!! I could not find any videos out there. Can I use a lithium? Any help is welcomed, thanks
  9. Thread: Stator/Rotor

    by butchcr
    Replies
    6
    Views
    3,020

    For Mesozoic or anyone looking to swap out...

    For Mesozoic or anyone looking to swap out stator/rotor. I talked with the EBR tech. last night and told them everything I did with the Rick's parts on the bike. EBR is saying the Hot Shot voltage...
  10. Thread: Stator/Rotor

    by butchcr
    Replies
    6
    Views
    3,020

    I sent back the rotor core to EBR for the core...

    I sent back the rotor core to EBR for the core charge. They are going to let me know what the differences are when they get it. I am 100% sure it was an OEM I took off. I will let you know when i get...
  11. Thread: Stator/Rotor

    by butchcr
    Replies
    6
    Views
    3,020

    Stator/Rotor

    I just did a new stator/rotor upgrade. Rick's hot shot volt. reg., and stator. EBR upgraded rotor, new crank nut, etc. My stock rotor had a drill mark, but my new EBR had three, better for oil I...
  12. Replies
    15
    Views
    10,194

    I too bought a 09 CR, I checked with the dealer...

    I too bought a 09 CR, I checked with the dealer it was bought from and they did a recall for the voltage reg. (new wire harness for better ground). It only has 1,700 miles. I am concerned with the...
  13. Thread: butchcr

    by butchcr
    Replies
    5
    Views
    5,368

    THANKS for the info.!! Will do.

    THANKS for the info.!! Will do.
  14. Thread: butchcr

    by butchcr
    Replies
    5
    Views
    5,368

    Tune

    Thanks! i will research these out. I see you on here a lot, witch one would be your advice on what to do?
  15. Thread: butchcr

    by butchcr
    Replies
    5
    Views
    5,368

    butchcr

    I got a 1125cr and thinking of putting on the HMF exhaust kit. HMF say i don't have to anything other than bolt it in. I also want to run a KN air filter. Has anyone done this? Do i need to remap...
Results 1 to 15 of 15