Search:

Type: Posts; User: 34nineteen

Page 1 of 20 1 2 3 4

Search: Search took 0.34 seconds.

  1. Replies
    6
    Views
    107

    If you really think you have a knock, take the...

    If you really think you have a knock, take the primary off, take out the spark plugs and spin the motor over by hand and see if you can feel the knock. "Push" the piston one way with the crank to...
  2. Replies
    12
    Views
    207

    Hell Fi - re! Hell Fi - re! Hell Fi - re! ...

    Hell Fi - re! Hell Fi - re! Hell Fi - re!

    All hail the Hell Fire Pro Race exhaust!

    * Hell Fire Exhaust is a registered trademark of Lunatic Fringe Heavy Industries.
  3. Replies
    58
    Views
    1,871

    You know, I really don't like the show. I enjoy...

    You know, I really don't like the show. I enjoy the premise, but I find the hosts annoying.
  4. This is useless info. The motorcycle is NOT going...

    This is useless info. The motorcycle is NOT going to the moon. He needs to stick to metric or all the calibrations will be lost. John, you should especially know this since you were a former...
  5. Will any other size work???

    Will any other size work???
  6. Replies
    33
    Views
    635

    Get a can of starting fluid and remove the air...

    Get a can of starting fluid and remove the air filter. Start it up, and when it "chokes out" spray some starting fluid into the intake.

    If its fuel starvation, the motor should continue to run as...
  7. Replies
    7
    Views
    149

    Take the rear fairing off. You can squeeze around...

    Take the rear fairing off. You can squeeze around it if you have patience, but the time spent removing the 6 bolts and pulling the rear fairing is much less than you'll spend fiddle-f*cking around...
  8. Wait... wut? Are you starting a new "OK... Bye"...

    Wait... wut? Are you starting a new "OK... Bye" thread?
  9. Replies
    30
    Views
    3,413

    Ha! You’re probably better not mentioning my...

    Ha! You’re probably better not mentioning my name. Lol
  10. Replies
    30
    Views
    3,413

    35mm film... whats that ? At this point, a...

    35mm film... whats that ?

    At this point, a Seal Mate is probably less expensive and easier to find than 35mm film.

    Here is a pic of Cooter dropping off 35mm film :black_eyed:
    ...
  11. Replies
    30
    Views
    3,413

    You may want to use a seal mate to try to clean...

    You may want to use a seal mate to try to clean out the seal. Since it is the right side, it tends to get dirtier due to brake dust in addition to normal road grime.

    I have a spring compressor...
  12. Replies
    33
    Views
    635

    fixed it for you

    fixed it for you
  13. Replies
    33
    Views
    635

    I did not know that. I figured since Harley...

    I did not know that. I figured since Harley phased those in after the 1st year the carb was put on the Sportsters, it on all of them.

    Thanks for the heads up !!! :up:
  14. Replies
    33
    Views
    635

    I made a small aux fuel container for when I had...

    I made a small aux fuel container for when I had my SV650. On that bike the carbs were under the fuel tank, and you couldnt access them without the tank flipped up or disconnected.

    Anyhow, it was...
  15. Replies
    33
    Views
    635

    Here is a link to how the CV carb processes gas...

    Here is a link to how the CV carb processes gas and air. The fun parts starts at about the 4 minute mark.

    https://www.youtube.com/watch?v=-B-fLDOBqzo
  16. Replies
    33
    Views
    635

    You may want to pull the cover off and inspect...

    You may want to pull the cover off and inspect the ignition pickup for water intrusion. It could be that the pickup has been compromised and moisture is causing it to act up. Bring a sharpie with you...
  17. Replies
    33
    Views
    635

    My M2 had the needle jet in upside down when I...

    My M2 had the needle jet in upside down when I bought it. I bought it from a indy Harley shop, and he couldn't figure it out either.
  18. Replies
    2
    Views
    122

    You may want to put a price in your ad.

    You may want to put a price in your ad.
  19. Replies
    4
    Views
    175

    Hmmm... Damn... Sigh... ...

    Hmmm...


    Damn...


    Sigh...

    :indecisiveness::indecisiveness:
  20. Replies
    62
    Views
    33,403

    https://www.youtube.com/watch?v=TdUK6RPdIrA

    https://www.youtube.com/watch?v=TdUK6RPdIrA
  21. Replies
    33
    Views
    635

    Informative article!

    Informative article!
  22. Replies
    7
    Views
    137

    You may also want to ask Chandler HD. I think...

    You may also want to ask Chandler HD. I think they were a Buell dealer back in the day and hopefully may have a tech who appreciates them.
  23. Replies
    9
    Views
    190

    That’s probably not going to work on a Firebolt.

    That’s probably not going to work on a Firebolt.
  24. Replies
    33
    Views
    635

    Also, check to make sure the slide is opening...

    Also, check to make sure the slide is opening when you open the throttle.

    If it’s not, do this check...

    https://youtu.be/lfQz4cxezAk


    And be sure to put the jet holder back in the correct...
  25. Replies
    7
    Views
    137

    It’s really not that bad of a job. You could...

    It’s really not that bad of a job. You could probably do it with the forks in place, but you will need a way to reliably support the front end of the bike.

    Btw, my last post really only applies to...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4