Interesting article on that fan, the guy just wired in a manual switch for the fan instead of being controlled by the ecu. Has anyone wired in a cylinder head temp gauge on one of these?
Type: Posts; User: ontheroad68
Interesting article on that fan, the guy just wired in a manual switch for the fan instead of being controlled by the ecu. Has anyone wired in a cylinder head temp gauge on one of these?
So I installed the Fan fuse and plugged in the fan, I was then able to clear the code (36). My bad. I also checked ALL the wires to the fan from the ECM and The fuse box for continuity and short to...
So I pulled the rear shock and fan to do some research and this is what I found:
- Before I pulled the fan out the CEL remained constant and code 36 (fan) will not clear, fan tested fine before...
Yep, using the ECM droid. Live temps look normal for the minut or so I checked, but the CEL is on steady now and the fan code 36 will not clear. I should have some time this week to pull the rear...
Hmm, not sure what the difference is between the Mono and the not, I just downloaded it onto my android device but it does not look like the screenshots you just sent. I have the option of looking at...
Checked the fan parameters this morning and they all looked normal, fan on at 220C, off at 180C. Next step is to start it up and check temps while running which I didn't have time to do today, so...
I haven't gotten in depth with the ECM spy yet, I just had time to plug it in, check the code and turn on the fan. I'd like to see what the parameters are for the fan, it seems to me they are set...
I turned the fan on a few times via ECM SPY and it seemed to work fine. Though it didn't always sound great, the bearing maybe on its way out. If there was a wire open it would be an intermittent...
Got code 36, FAN. At this point the manual says I need a Break-out box, which I do not have. The CEL light has come on while riding, usually for just a minute or so. The other problem is that the FAM...
YOU THE MAN!!!!
I looked at all the wires in the area and nothing goes there. The connector and all the wires are completely hidden until you pop the panel off. When the manual said "Left side...
The only place I haven't looked (yet) is behind the headlight, which according to the manual is only use for Firebolt models.
This is driving me nuts. I have a 2008 Uly XT and my check engine light has come on periodically, so I went to check the codes. But to do that I need to find the Data Link Connector. According to my...
I've found a Uly in Maryland I'm planning to buy, but I live out of state and was hoping someone might be close by and can just go take a quick peek at it before I wire money over state lines. Anyone...
What did you paint the engine with?