One minor annoyance is that something is wrong with the kickstand kill switch. Any time I out the kickstand down (even in neutral) the motor stops.
faulty sidestand switch....disconnected switch...
Type: Posts; User: Barrett
One minor annoyance is that something is wrong with the kickstand kill switch. Any time I out the kickstand down (even in neutral) the motor stops.
faulty sidestand switch....disconnected switch...
the previous owner lied to you. just as Dave mentioned...pump-related problem.
was clearly evident on 2-18 when you commenced this thread that your problem was simply "fuel pump delivery" related.
red circled logo confirms that it's the rare and highly coveted E-I-E I-O dealer option only light by Old MacDonald Corp...a former subsidiary of MacDonald-Douglas Aviation. producers of desirable...
XB "over-heating" typically results in assorted oil leaks ABOVE the engine case assembly...cracked header assembly...broken exhaust port flange studs. if the rest of that Ulysses is as corroded as...
2008 and up models have the capability of resetting the TPS via activation of twist-grip and ignition/kill switch in proper sequence. 2003-2007 do NOT.
you will need to access your ECM thru the...
is this outfit planning on peddling the marque as store-front "boutique" bikes? because no existing legit north american dealership would ever touch these again. and a start-up, other than BMW or...
PART NUMBERS:
OEM part #--26995-86B.......in stock at most all H-D dealers. sold individually
JAMES part #--26995-97-X....available thru several H-D online dealers and ebay.
Jim: in the world of XL's....XR's...XB's...and P3's, your problem is more common than you'd think. it's a 4-stroke single so keep in mind that if it has compression-spark-fuel-timing, it has no...
Sir: all ZTL-2 front calipers use EBC FA454/4HH front pads, regardless of model application.
all ZTL front calipers use EBC FA345HH front pads, regardless of application.
you can use those EBC...
More tried-and-proven unassailable "geezer" formulas for longevity and performance:
1-add 1 quart of either diesel fuel or kerosene to the crankcase the day prior to anticipated oil change. removes...
yes sir Bob, my pleasure. like mentioned above, with a fully charged Deka house-brand battery and the headlight fuse removed...i made it home safely which was a tick over 40 miles from the initial...
Bob: can i suggest one that you might like? it's cube shaped...very accurate...about 1-1/4" X 1"....choice of red or blue LED's. i've installed probably 15 of these thru the years on assorted XB's...
BUELL XB/1125 SERIES master cylinder info as follows:
all ZTL OEM equipped models have the following FRONT master cylinder:
part # N0200.1AJ-----suffix L18A. still available....original list...
yes sir my pleasure. i'm sure "shimming" the difference that you've been mentioning between the fork slider, and the lower triple clamp location holes has been done before. BUT keep in mind that the...
Purportedly, a few of those pesky and tedious board members such as Shaughn...Aaron.......Stevie.....Ricky Huff....probably a few others....reported me to site owner Paul, as a serial trouble-maker...
there is a wide variety of triple clamp combinations as well as fork tube specs for the entire run of XB series buells.
to keep it simple, so that identification of your parts as well as what the...
David: i would NOT continue to ride it until the exact cause is identified and repaired. in all probability, your simple "barrel adjustment" is a temporary cure with a predictable short life-span....
with chambers. as it should be.
14947
14948
my pleasure sir. below are the appropriate part numbers when you go shopping for your P3 parts. i checked the supply chain for you and many of each number still available thru authorized dealers....
Sir: as you mentioned, procedures...torque values...L&R hand thread scenario very similar
1-engine crankshaft end right hand threads
2-trans input shaft left hand threads
3-nut sizes are 1-1/8th...
hostile combative F-bomb laden responses, particularly from a "board moderator", reflects poorly on this entire site and its members. immensely disappointing.
Ya Boss......forums are still "a thing". Here in AmishLand, the pussification of America is heavily shunned. Such oddities as safe spaces, man-purses and hair-buns, kneeling during our National...
INFO:
many XB parts interchange between years and models
the difference between the 9 and the 12 motors is a mere 219cc. that difference achieved via stroke dimensions
though i never had any...
XB's do NOT have a "cush drive" in the normal sense of the word.
a combination of the clutch pack assembly "judder spring compensating plate"...along with the actual drive belt...is a form of a...
Next Up: the incomparable John Vreede and his doctoral thesis on "grounds".
PS-LunticFringe aka user_deleted also quite windy and flatulent.
...