Search:

Type: Posts; User: pdksh

Page 1 of 13 1 2 3 4

Search: Search took 0.30 seconds.

  1. Replies
    23
    Views
    1,632

    Yes, when you try to remove the wheels and the...

    Yes, when you try to remove the wheels and the previous owner torqued them down to 200+ ft-lbs and you need a 4 ft breaker bar to loosen the axle. Stop, order wheel bearings and inner wheel...
  2. Replies
    25
    Views
    1,712

    Just to add my useless 2 cents. I have a D&D on...

    Just to add my useless 2 cents. I have a D&D on an XB12R... LOUD and TANGY is the way I would describe it. I'm not a fan of the sound. I preferred the Jardine can that it replaced BUT before you all...
  3. Replies
    13
    Views
    987

    34:19 and Cooter have some sort of "special" bond...

    34:19 and Cooter have some sort of "special" bond going on that I personally find uncomfortable. My 2 cents... Disconnect the brakes (if they work) and roll her down the largest hill you can find,...
  4. Replies
    8
    Views
    622

    Bike is a 2008, no steel/bronze oil pump drive...

    Bike is a 2008, no steel/bronze oil pump drive gear. Hammer Performance recommends 70lbs with red lock tight. The manual has a procedure that accorcding to H.P. works out to 50lbs.
  5. Replies
    13
    Views
    987

    And I'm the F#@K'n insane one?

    And I'm the F#@K'n insane one?
  6. Replies
    24
    Views
    1,530

    I enjoy my “black scorpion”, your “red dragon “...

    I enjoy my “black scorpion”, your “red dragon “ is a nice score/fix! Is it just me but are ALL previous Buell owners abusive riders that don’t stay up on basic maintenance? These things aren’t...
  7. Replies
    8
    Views
    622

    I had no idea the GS could “get over” my poor...

    I had no idea the GS could “get over” my poor assumption. I have never been much of a fan of BMW, butt ugly IMHO.

    Thx for the BBQ tip?
  8. Replies
    8
    Views
    622

    Hind sight is always 20/20, its hard not to...

    Hind sight is always 20/20, its hard not to overthink the diagnostic process. I try to take "known" issues into account first, really shaves off the hours. I was very fortunate to have a good ECU and...
  9. Replies
    10
    Views
    2,200

    BEST LINE EVER! Made my morning Cooter. ...

    BEST LINE EVER!

    Made my morning Cooter.

    Yes its an old post but...
  10. Replies
    17
    Views
    1,184

    Thank You

    Thank You
  11. Replies
    4
    Views
    1,078

    Thank You for the shopping list of parts Barrett!...

    Thank You for the shopping list of parts Barrett!

    Gotta love cross reference part numbers
  12. Replies
    17
    Views
    1,184

    How did you contact tootal? Bad weather? How long...

    How did you contact tootal? Bad weather? How long ago did you order the shaft?

    My buddies S3 throttle shaft splintered and a screw made it into the intake… I think I’m going to replace the shaft...
  13. Replies
    12
    Views
    1,402

    Saw an XB12S a couple of years ago with a rod...

    Saw an XB12S a couple of years ago with a rod attached to the front end to be used with highway pegs. In one word “Awful” I’ve never considered highway pegs, strictly because of the look. It’s my...
  14. Replies
    19
    Views
    1,193

    Point taken. All about the shock value

    Point taken. All about the shock value
  15. Replies
    8
    Views
    622

    No Spark, No Gas, No GO!

    The saga between me and my XT has been a little tumultuous over the past six months, so bad that I picked up a Yamaha SuperTenre. In the spring I was blasting down a country highway, about 30...
  16. Replies
    19
    Views
    1,193

    Barrett, I was totally upfront about playing...

    Barrett,

    I was totally upfront about playing with a non daily rider and NOT blaming the bike or asking for tons of free tuning advice. No cause for concern at all. I wanted to know if others had...
  17. Replies
    19
    Views
    1,193

    I reloaded my race map and let it idle for a...

    I reloaded my race map and let it idle for a while. The AFV was 100% because I reset it. The O2 sensor hummed nicely, apparently working and the EGO hovered around 120%

    The rear pipe did obtain a...
  18. Replies
    19
    Views
    1,193

    34-19 it was SMOKING HOT!!! according to your...

    34-19 it was SMOKING HOT!!! according to your burn-o-matic gage so around 500 degree C im assuming. Way Too Warm, I don't have to shave the right side of my face HOT. The rear header was notably...
  19. Replies
    19
    Views
    1,193

    thank you for the very detailed reply. Looks...

    thank you for the very detailed reply.

    Looks like I have some homework to do.

    1) I'm messing around because I can, not my daily ride.
    2) Bike was/is running fine. It had a stock tune and a...
  20. Replies
    19
    Views
    1,193

    When I reverted back to the original EEPROM/MAP...

    When I reverted back to the original EEPROM/MAP the glowing header problem goes away. Im going to leave the factory/stock map on the bike until I can go for some butt dyno runs.

    When I say the...
  21. Replies
    19
    Views
    1,193

    RACE MAP vs STOCK MAP - EXTRA LEAN GROUND BEEF!

    Happy new year folks. I added a 2007 XB12R to the stable, i wanted a 2010 XB9 for the extra cool blacked out stuff but I couldn't resist the price. Like most Buells, she had a rough life and I have...
  22. Replies
    10
    Views
    1,409

    Found three wires in the triple clamp area that...

    Found three wires in the triple clamp area that failed the “pull test” patched them, but still no love. Very intermittent spark, the clean spark plug feature and ECMspy test both fire nice. Still...
  23. Replies
    10
    Views
    1,409

    actually I get spark intermittently when I wiggle...

    actually I get spark intermittently when I wiggle the wires. As a rule, no spark. Yep a nice/beeping FLUKE meter. Ill go over the kill switch/ignition switch. Need to get the current bike of the...
  24. Replies
    10
    Views
    1,409

    the grounds are all good, At the neck and the two...

    the grounds are all good, At the neck and the two under the seat. Added fresh star washers and checked for broken connections. I will tear into the triple clamp and wire harness after I give the bike...
  25. Replies
    10
    Views
    1,409

    I forgot to mention that I metered all fuses...

    I forgot to mention that I metered all fuses (good) and swapped the relays around. They appear to be the same part number (stamped in the plastic) still no love...
Results 1 to 25 of 307
Page 1 of 13 1 2 3 4