Search:

Hi,

Thanks for the input. I’ve gone into the service manual trying to find out if the injectors can be removed without taking half the bike apart, with no luck. If you have removed them, please...

Well I called the dealer here in Dothan Alabama and was told they don’t work on Buell’s. Now starts the search for someone that does. The bike only has 13K miles on it and I’m pissed at myself for...

Set for almost two years, but in my defense I have a Ultra Classic and Fatboy that I do most of my riding on. Still no excuse. I think I’m going to bite the bullet and take it to the dealer. That is...

Checked all things in your reply and nothing out of the ordinary. When I jump the wires and turned the switch on, I get six rapid check engine lights followed by 1, 1, 1, 1, and then the six again.

I made a mistake and let my Buell (09 Ulysses) sit too long without riding it and now it won’t start. I replace the plugs (made sure I had spark from both plugs) and drained all the old fuel out. I...

Thank you. I had one for my 09 and lost it and when I purchased a new one it said for 0?-08 (can't remember the first year is started with). I'm familiar with the different version of ECMSPY, but...

Hi,

Is the ECMSPY cable the same for 07 and 09 Ulysses?

Thank you!

Doug

Took it out yesterday and rode to the Bama Jam fairgrounds, about 20 miles round trip. It stalled about 6 times on the short ride. I would be riding along at 60mph and it would just stop running. ...

Thank you stellio78. I ordered one of the tool kits.

Hi,

I bought my 2009 Ulysses used and it did not have the toolkit with it. Anyone know where I can get the original kit with the axle tool. I see kits on Ebay, but they do not have the special...

I got mine from the following place nd just went on 2500 mile trip and it worked great.

Doug

California Scientific
4011 Seaport
West Sacramento, CA 95691
...

I got the following from the EBR tech to do after installing the ECM.

Two things need to be done after install of this race ECM to make sure everything works properly:

1) TPS re-set
Turn key...

Mine was about ten days, however it varies depending on how many he has to do when you send your's in. My bike sounds great and now with EBR ECM it runs great with no more stutters and coughs off...

Hi,

I'm looking for a low seat for my 09 Ulysses, part number 51901-06YA. If anyone has one they don't need or know where I can get one, please email at 19stang64@gmail.com. Thank you

Doug

Sprayed it with lub and after letting it set for a while and with much wiggling, it is now working. Thanks

Anyone ever have the triple tail stick on them. Mine is stuck in the upright position and no matter how hard I push in the unlock it won't slide to the rotate position. Any ideas except head to the...

Do I turn the key off between each full open and close cycle, or only on the last sequence? I think it says key on, kill switch on, and then 3 cycles of full open and close fof one second duration...

Hi,

I sent my stock muffler from my 2009 XB12XT to Keven Dumm (KDFabrications) and had him make a dummer out of it and it really sounds good. I also replaced the stock air filter with a K&N. My...

Hi,

I would like to remove the brush guard from my XB12XT and was wondering where to get bolts that would replace the one that are used to mount the guards. I could leave it like is is, but would...