Friend also said thank you.
Type: Posts; User: ztied
Friend also said thank you.
Thank you Sir
so it appears 1 of the wires to the voltage meter (voltage meter mod) got smushed under the cover, and was pierced on a solder point.
Can the speedometers be swapped around and register the...
Yes it is the tall seat, but I need extra cushion
So finally an update, I am convinced,it is in the speedo cluster. I put a plug in voltage tester in the cigerrette lighter plug, and it stays at normal voltage, while the built in one goes to .02v...
Seat came fast, and cheaper then used. Just in case any one needs 1.
Thank you Barrett, Good advice, I will check that next time I get a chance to work on the bike
Also like cooter suggested, almost a small part of me is thinking dash or my dash mod guage is acting up. I will also check that.
It almost does it like part of a functions check, like when you start your car, and it runs through the tests, The Grounds recleaned, and have multiple extra ground wires run, as a secondary ground...
Here is the seat if anybody needs 1. I was hoping to get it for 106, but they didn`t respond to my offer, so I paid about 130 with shipping and taxes.
Super cheap, and you can`t beat the shipping...
Thanks for all the input, I just pulled the bike out of the garage to start tracking down the issue, getting to be time to ride. Few updates here
Upon starting bike, will show 12.9 volts, after a...
I was following it, and just a few miles from the house. almost 5 years ago.
Thanks Cooter I just watched that, I may have found a new complete one shipped for 106.00. I did buy the vinyl a few months ago, May still try to cover that one.
Lets see if I can post picture. Kinda neat to me.
Would prefer to buy a new seat cover, if available. Before I try to recover myself.
Any ideas out there.
Thats what I am stuck on. I will take dash apart, and see where I soldiered to. If I soldiered to the light circuit on the circuit board, it wouldn`t affect the speedometer needles, but why the cel?...
The voltmeter is wired into the speedometer circuit board. Don`t remember which part of board I soldiered it to. I haven`t had a chance to dig into it yet
Sorry about link, but yes I was promoting Barrett. Try it this way look up item 175840455972 on ebay.
His kits include the fuel level sensor, and all orings.
No problem John. It`s hard to find good...
I would recommend
https://www.ebay.com/itm/17584045597...Bk9SR9yd7tu4Yg
He`s a member here goes by Barret.
Very trustworthy, fast shipper, and will help you with any questions.
I believe he...
Thanks again Sir, I will look into that also.
Thanks John, No problem on the words, Thanks for the input also. I will recheck everything
I would go with Barrets ebay link, he is a fast shipper, and a trustworthy seller
Thanks for the fast input, I will go over the grounds
The 77 connector was bypassed along time ago.
2006 xb12x 25,000 miles, I have the mod with the volt gauge modified in my speedometer.
Started happening slowly, usually after about 10 miles on interstate (higher speeds), Now it is more frequent....
What about one of those rubber like freeze plug thingies. (put plug in hole, then tighten bolt, and rubber expands) Would at least get got riding without a mess, as long as you know oil level is good