Also, I never though that greasing the throttle cable would help but it did make a real improvement.
Get some WD lube vaseline.
Type: Posts; User: hoshinoa
Also, I never though that greasing the throttle cable would help but it did make a real improvement.
Get some WD lube vaseline.
What AFV Value before the Ride and after the ride?
Well. If u read some of my thread, I had the same problem before. Check your electrical wires. Especially the one at the neck.
Ok. End of the story is:
I added a switch under the sit to shortcut the key.
At the relay between 9 and 15. So I dont need a key anymore. I still locked the bike and I have an alarm but I just need...
Is the air going in or out the transmittion?
Thanks guys. I replaced the pipe. It's a pain in the bump. No room at all. Didn't want to remove the starter. Any way, i managed to fit a new one.
For some reason, the gaz that comes out off this...
So nothing to worry? Do I need to replace?
Hot oil on the kickstand. Don't wait 5mns after your ride.
http://www.buellxb.com/buell_images/18418_20140412172053_L.jpg
Is anyone knows what this pipe is for. During my normal inspection I found this.
It goes fron the top of the engine to behind the battery. If any one know what is it. Thanks for helping
Ah ah very funny.
Modern bike mate. 20 sec tps reset. Turn engine off and open close throttle three times. No computer needed.
I damage the wire by pulling them out when I change the spark plugs.
Still new with Buell but I love it so far.
what I learned since 2 months using the buell every day to go to work with 100 km daily and maybe 30 km in real traffic Jam, is Do No Touch things that...
Never mind found one
Crack ECM box. move the ECM to different location.
The ECM control the Idle.
Is anyone have a clear electrical diagram for a 2009 xb 1200 , i try to get one of internet but there are not clear.
Thanks
What I though happened back from work. Twisted my handle bar to go thru traffic and here we go again. Bad contact at ignition switch wire somewhere. Grrrrr have to tps reset every time now. ...
I wish I can x-ray my bike and see all the small imperfections. I will have to live with it as I check every where. I know it's somewhere and it will happen again. But for now it's working. I will...
Thanks Ron,
I open the ignition switch apart as per your recommendation, but nothing look wrong with it. Put everything back together and clean up the grounds, find some special sticky tape at the...
Thanks Shawn,
I checked that one too. It deosnt seem that I can make it happen anymore. It may be fixed by opening and moving wires. I really want to find that broken or lose wire as I dont want to...
Guys,
I have a broken wire or a bad connection somewhere at the handlebar.
When I turn my handlebar to a certain position all the electrical goes down. No power.
Its only a fraction of a...
When I ride my bike I can hear my bike inhale air between gears. Especially 1, 2 and third gear.
It's like my bike is alive and inhale between gear.
Is yours the same?
nullhttp://www.buellxb.com/buell_images/18418_20140316171947_L.jpg
This is the relocation I' ve done. Much lower tgan stock. Just bended the bracket
I check the bike today, and I took the Ecm out, it appears that it has a very small crack near the connector as usual. add the superglue and change location, it's fixed now. previously I had some...
Ronin, Not the sensor just the spark plug leads. The spark plug wire. connect the spark plug to the coil
Guys, great forum, it helps a lot thru people’s experience.
This is my story,
I moved from WA to QLD Brisbane 4 weeks ago. Needed a Bike to commute to work every day for my new job,
Jumped...