Search:

Type: Posts; User: Pushr0d

Search: Search took 0.07 seconds.

  1. Thread: Buying a Uly

    by Pushr0d
    Replies
    4
    Views
    157

    Only issue to check other than engine/electrical...

    Only issue to check other than engine/electrical is the rear wheel bearings (esp. right side) and the belt.

    If the only problem you have is a 'hesitation', it sounds like the bike is in pretty...
  2. I had a hell of a time with the 'barbed' style...

    I had a hell of a time with the 'barbed' style you reference, Cooter. I believe the OEM bits (having never seen them - the previous owner had the cables ziptied to the frame!) are the 'fuzzy'...
  3. Replies
    3
    Views
    343

    I've had very nice results with olive oil. Works...

    I've had very nice results with olive oil. Works best when the plastic is warm.

    Clean it first with a stiff bristle brush and a strong detergent (like Dawn), dry thoroughly, then wipe it down...
  4. And, look at the ECM and see if the connectors...

    And, look at the ECM and see if the connectors are properly connected, and that the ECM itself is okay.

    Apparently there is an issue where the seat can press down on the unit and crack it. I'm...
  5. Replies
    10
    Views
    1,819

    +1 on the above posts. I've had my '08 since...

    +1 on the above posts. I've had my '08 since spring, and have found that I use the T27 a lot. I bought a t-wrench and an extra 1/4" drive T27 bit to supplement my toolbox. If you have the OEM...
  6. Replies
    15
    Views
    1,629

    Yep! Pipe still available, and the baffles were...

    Yep! Pipe still available, and the baffles were 'gently' pressed in. I left them proud so you can grab them and pull them out.
  7. Replies
    18
    Views
    1,366

    Joe, I feel your pain! I can't figure out how to...

    Joe, I feel your pain! I can't figure out how to attach a photo to a PM! Look at the 'Aftermarket Parts' thread at the top of the page.

    Pr
  8. Replies
    18
    Views
    1,366

    I just added a photo to the 'Parts' thread.

    I just added a photo to the 'Parts' thread.
  9. Replies
    15
    Views
    1,629

    Additional Photo showing dent

    Here is a shot of the belly of the exhaust.
  10. Replies
    18
    Views
    1,366

    Sure - PM me your email address.

    Sure - PM me your email address.
  11. Replies
    18
    Views
    1,366

    joeharley, I have a 'SpecOps' muffler that I'm...

    joeharley, I have a 'SpecOps' muffler that I'm selling - look for the thread (in aftermarket parts). It'll wake the neighborhood if you pull the baffles out!

    pr
  12. Replies
    15
    Views
    1,629

    SpecOps(?) Exhaust off of '08 XB12XT

    --- SOLD! ---

    Selling the can that came with the bike. WAY too loud for me - I added baffles, but still didn't like it. I replaced this one with a stock can.

    The one I'm selling has no rust,...
  13. Thread: Clutch lever

    by Pushr0d
    Replies
    12
    Views
    1,237

    I bought a well-used '08 Uly that had a very...

    I bought a well-used '08 Uly that had a very well-used clutch lever. The pivot hole was egged out to almost the edge of the lever!

    I bought another used clutch lever and perch off eBay. Cleaned...
  14. Replies
    9
    Views
    784

    Congratulations on the 'new' bike! I just...

    Congratulations on the 'new' bike!

    I just bought my first Buell, also an '08 XB12XT, about a month ago. Mine has had some trials and misfortune with Previous Owners - I've about gotten them all...
  15. Replies
    5
    Views
    661

    Roger the clear film, and thanks for the clutch...

    Roger the clear film, and thanks for the clutch cable adjustment procedure!
  16. Replies
    31
    Views
    3,062

    Today - My First Ride on my (new to me) '08 'T'. ...

    Today - My First Ride on my (new to me) '08 'T'. Fun bike - the PO had a rather 'sporty' exhaust put on, so I had a pretty good sound track, as well as a spirited ride to work.

    Backfires a lot on...
  17. Replies
    5
    Views
    661

    Sorry I was not clear, but I'm trying to get...

    Sorry I was not clear, but I'm trying to get familiar with the bike, and there's not another one around I can look at.

    The racks all have some sort of tape or padding on the surfaces the bags rest...
  18. Replies
    5
    Views
    661

    Luggage Rack 'Padding' Rotting Off

    Hello! I just bought a 2008 T, and one of the issues it has is the padding/tape/rail guard material on all the bag rails has aged badly, and is cracked, peeling and flaking off. Anyone know what it...
Results 1 to 18 of 18